The two pieces are bolted together, not too tight, and the points of the tripod legs inserted in their respective small holes. So set up, there is absolutely no danger of one of the legs slipping out of position. By moving the position of the bolt from, one to another of the larger holes in the strip, Fig. 2, almost any desired inclination of the camera can be secured.
The same sort of simple apparatus built slightly stronger, and with a small caster under each of the three series of small holes, makes an excellent tripod clamp for use when the camera has to be shifted about, as in portraiture and the like.
How to Weave a Shoestring Watch Fob
Fobs Made from Shoestrings
Having procured a pair of ordinary shoestrings, take both ends of one of them and force the ends through the middle of the other, leaving a loop 1-1/2 in. long, as shown in Fig. 2. In this sketch, A is the first string and B is the second, doubled and run through the web of A. Take hold of the loop and turn it as shown in Fig. 2, allowing the four ends to hang in four directions. Start with one end, the one marked A, in Fig. 1, for instance, and lay it over the one to the right. Then take B and lay it over A, and the one beneath C; lay Cover B and the one under D, and then lay D over C and stick the end under A. Then draw all four ends up snugly. Commence the next layer by laying the end A back over B and D; D over A and C; C over D and B, then B over C and the end stuck under A. Proceed in the same manner and keep on until about 1-1/2 in. of the ends remain unwoven. Four pins stuck through each corner and into the layers will hold the ends from coming apart. The ends of the strings are raveled out so as to make a tassel. This will make a square fob which will appear as shown in Fig. 4.
A round fob is made in a similar way, taking the same start as for the square fob, but instead of reversing the ends of each alternate layer, always lap one string, as at A in Fig. 3. over the one to its right, as B, slipping the last end of the four strings under and tightening all, as in making the square fob. Fasten the ends with pins and ravel out for a tassel. The round fob is shown in Fig. 5.