Flax prospers most when grown upon land of firm texture resting upon a moist subsoil. It does well to succeed oats or potatoes, as it requires the soil to be in fresh condition without being too rich. Lands newly broken up from pasture suit it well, as these are generally freer from weeds than those that have been long under tillage. It is usually inexpedient to apply manure directly to the flax crop, as the tendency of this is to produce over-luxuriance, and thereby to mar the quality of the fibre, on which its value chiefly depends. For the same reason it must be thickly seeded, the effect of this being to produce tall, slender stems, free from branches. The land, having been ploughed in autumn, is prepared for sowing by working it with the grubber, harrow and roller, until a fine tilth is obtained. On the smooth surface the seed is sown broadcast by hand or machine, at the rate of 3 bushels per acre, and covered in the same manner as clover seeds. It is advisable immediately to hand-rake it with common hay-rakes, and thus to remove all stones and clods, and to secure a uniform close cover of plants. When these are about 2 to 3 in. long the crop must be carefully hand-weeded. This is a tedious and expensive process, and hence the importance of sowing the crop on land as free as possible from weeds of all kinds. The weeders, faces to the wind, move slowly on hands and knees, and should remove every vestige of weed in order that the flax plants may receive the full benefit of the land. When flax is cultivated primarily on account of the fibre, the crop ought to be pulled before the capsules are quite ripe, when they are just beginning to change from a green to a pale-brown colour, and when the stalks of the plant have become yellow throughout about two-thirds of their height.
The various operations through which the crop passes from this point till flax ready for the market is produced are—(1) Pulling, (2) Rippling, (3) Retting, (4) Drying, (5) Rolling, (6) Scutching.
Pulling and rippling may be dismissed very briefly. Flax is always pulled up by the root, and under no circumstances is it cut or shorn like cereal crops. The pulling ought to be done in dry clear weather; and care is to be taken in this, as in all the subsequent operations, to keep the root-ends even and the stalks parallel. At the same time it is desirable to have, as far as possible, stalks of equal length together,—all these conditions having considerable influence on the quality and appearance of the finished sample. As a general rule the removal of the “bolls” or capsules by the process of rippling immediately follows the pulling, the operation being performed in the field; but under some systems of cultivation, as, for example, the Courtrai method, alluded to below, the crop is made up into sheaves, dried and stacked, and is only boiled and retted in the early part of the next ensuing season. The best rippler, or apparatus for separating the seed capsules from the branches, consists of a kind of comb having, set in a wooden frame, iron teeth made of round-rod iron 3⁄16ths of an inch asunder at the bottom, and half an inch at the top, and 18 in. long, to allow a sufficient spring, and save much breaking of flax. The points should begin to taper 3 in, from the top. A sheet or other cover being spread on the field, the apparatus is placed in the middle of it, and two ripplers sitting opposite each other, with the machine between them, work at the same time. It is unadvisable to ripple the flax so severely as to break or tear the delicate fibres at the upper part of the stem. The two valuable commercial products of the flax plant, the seeds and the stalk, are separated at this point. We have here to do with the latter only.
Retting or rotting is an operation of the greatest importance, and one in connexion with which in recent years numerous experiments have been made, and many projects and processes put forth, with the view of remedying the defects of the primitive system or altogether supplanting it. From the earliest times two leading processes of retting have been practised, termed respectively water-retting and dew-retting; and as no method has yet been introduced which satisfactorily supersedes these operations, they will first be described.
Water-retting.—For this—the process by which flax is generally prepared—pure soft water, free from iron and other materials which might colour the fibre, is essential. Any water much impregnated with lime is also specially objectionable. The dams or ponds in which the operation is conducted are of variable size, and usually between 4 and 5 ft. in depth. The rippled stalks are tied in small bundles and packed, roots downwards, in the dams till they are quite full; over the top of the upper layer is placed a stratum of rushes and straw, or sods with the grassy side downwards, and above all stones of sufficient weight to keep the flax submerged. Under favourable circumstances a process of fermentation should immediately be set up, which soon makes itself manifest by the evolution of gaseous bubbles. After a few days the fermentation subsides; and generally in from ten days to two weeks the process ought to be complete. The exact time, however, depends upon the weather and upon the particular kind of water in which the flax is immersed. The immersion itself is a simple matter; the difficulty lies in deciding when the process is complete. If allowed to remain under water too long, the fibre is weakened by what is termed “over-retting,” a condition which increases the amount of codilla in the scutching process; whilst “under-retting” leaves part of the gummy or resinous matter in the material, which hinders the subsequent process of manufacture. As the steeping is such a critical operation, it is essential that the stalks be frequently examined and tested as the process nears completion. When it is found that the fibre separates readily from the woody “shove” or core, the beets or small bundles are ready for removing from the dams. It is drained, and then spread, evenly and equally, over a grassy meadow to dry. The drying, which takes from a week to a fortnight, must be uniform, so that all the fibres may spin equally well. To secure this uniformity, it is necessary to turn the material over several times during the process. It is ready for gathering when the core cracks and separates easily from the fibre. At this point advantage is taken of fine dry weather to gather up the flax, which is now ready for scutching, but the fibre is improved by stooking and stacking it for some time before it is taken to the scutching mill.
Dew-retting is the process by which all the Archangel flax and a large portion of that sent out from St Petersburg are prepared. By this method the operation of steeping is entirely dispensed with, and the flax is, immediately after pulling, spread on the grass where it is under the influence of air, sunlight, night-dews and rain. The process is tedious, the resulting fibre is brown in colour, and it is said to be peculiarly liable to undergo heating (probably owing to the soft heavy quality of the flax) if exposed to moisture and kept close packed with little access of air. Archangel flax is, however, peculiarly soft and silky in structure, although in all probability water-retting would result in a fibre as good or even better in quality.
The theory of retting, according to the investigations of J. Kolb, is that a peculiar fermentation is set up under the influence of heat and moisture, resulting in a change of the intercellular substance—pectose or an analogue of that body—into pectin and pectic acid. The former, being soluble, is left in the water; but the latter, an insoluble body, is in part attached to the fibres, from which it is only separated by changing into soluble metapectic acid under the action of hot alkaline ley in the subsequent process of bleaching.
To a large extent retting continues to be conducted in the primitive fashions above described, although numerous and persistent attempts have been made to improve upon it, or to avoid the process altogether. The uniform result of all experiments has only been to demonstrate the scientific soundness of the ordinary process of water-retting, and all the proposed improvements of recent times seek to obviate the tediousness, difficulties and uncertainties of the process as carried on in the open air. In the early part of the 19th century much attention was bestowed, especially in Ireland, on a process invented by Mr James Lee. He proposed to separate the fibre by purely mechanical means without any retting whatever; but after the Irish Linen Board had expended many thousands of pounds and much time in making experiments and in erecting his machinery, his entire scheme ended in complete failure. About the year 1851 Chevalier Claussen sought to revive a process of “cottonizing” flax—a method of proceeding which had been suggested three-quarters of a century earlier. Claussen’s process consisted in steeping flax fibre or tow for twenty-four hours in a weak solution of caustic soda, next boiling it for about two hours in a similar solution, and then saturating it in a solution containing 5% of carbonate of soda, after which it was immersed in a vat containing water acidulated with ½% of sulphuric acid. The action of the acid on the carbonate of soda with which the fibre was impregnated caused the fibre to split up into a fine cotton-like mass, which it was intended to manufacture in the same manner as cotton. A process to turn good flax into bad cotton had, however, on the face of it, not much to recommend it to public acceptance; and Claussen’s process therefore remains only as an interesting and suggestive experiment.
The only modification of water-retting which has hitherto endured the test of prolonged experiment, and taken a firm position as a distinct improvement, is the warm-water retting patented in England in 1846 by an American, Robert B. Schenck. For open pools and dams Schenck substitutes large wooden vats under cover, into which the flax is tightly packed in an upright position. The water admitted into the tanks is raised to and maintained at a temperature of from 75° to 95° F. during the whole time the flax is in steep. In a short time a brisk fermentation is set up, gases at first of pleasant odour, but subsequently becoming very repulsive, being evolved, and producing a frothy scum over the surface of the water. The whole process occupies only from 50 to 60 hours. A still further improvement, due to Mr Pownall, comes into operation at this point, which consists of immediately passing the stalks as they are taken out of the vats between heavy rollers over which a stream of pure water is kept flowing. By this means, not only is all the slimy glutinous adherent matter thoroughly separated, but the subsequent processes of breaking and scutching are much facilitated.
A process of retting by steam was introduced by W. Watt of Glasgow in 1852, and subsequently modified and improved by J. Buchanan. The system possessed the advantages of rapidity, being completed in about ten hours, and freedom from any noxious odour; but it yielded only a harsh, ill-spinning fibre, and consequently failed to meet the sanguine expectations of its promoters.