In his patent of 1782 Watt gives the following example of the improvement in thermal efficiency obtained by expansive working. Taking the diagram already given, if the quantity of steam represented by AB, or 300 cub. in. at 60 ℔ pressure, were employed without expansion, the work realized, represented by the area ABSF, would be 6000/4 = 1500 foot-pounds. With expansion to 4 times its original volume, as shown in the diagram by the whole area ABCTSA, the mean pressure (as calculated by Watt, assuming Boyle’s law) would be 0.58 of the original pressure, and the work done would be 6000 × 0.58 = 3480 foot-pounds for the same quantity of steam, or the thermal efficiency would be 2.32 times greater. The advantage actually obtained would not be so great as this, on account of losses by condensation, back-pressure, &c., which are neglected in Watt’s calculation, but the margin would still be very considerable. Three hundred cub. in. of steam at 60 ℔ pressure would represent about .0245 of 1 ℔ of steam, or 28.7 B.Th.U., so that, neglecting all losses, the possible thermal efficiency attainable with steam at this pressure and four expansions (¼ cut-off) would be 3480/28.7, or 121 foot-pounds per B.Th.U. At a later date, about 1820, it was usual to include the efficiency of the boiler with that of the engine, and to reckon the efficiency or “duty” in foot-pounds per bushel or cwt. of coal. The best Cornish pumping-engines of that date achieved about 70 million foot-pounds per cwt., or consumed about 3.2 ℔ per horse-power-hour, which is roughly equivalent to 43 foot-pounds per B.Th.U. The efficiency gradually increased as higher pressures were used, with more complete expansion, but the conditions upon which the efficiency depended were not fully worked out till a much later date. Much additional knowledge with regard to the nature of heat, and the properties of gases and vapours, was required before the problem could be attacked theoretically.
9. Of the Nature of Heat.—In the early days of the science it was natural to ascribe the manifestations of heat to the action of a subtle imponderable fluid called “caloric,” with the power of penetrating, expanding and dissolving bodies, or dissipating them in vapour. The fluid was imponderable, because the most careful experiments failed to show that heat produced any increase in weight. The opposite property of levitation was often ascribed to heat, but it was shown by more cautious investigators that the apparent loss of weight due to heating was to be attributed to evaporation or to upward air currents. The fundamental idea of an imaginary fluid to represent heat was useful as helping the mind to a conception of something remaining invariable in quantity through many transformations, but in some respects the analogy was misleading, and tended greatly to retard the progress of science. The caloric theory was very simple in its application to the majority of calorimetric experiments, and gave a fair account of the elementary phenomena of change of state, but it encountered serious difficulties in explaining the production of heat by friction, or the changes of temperature accompanying the compression or expansion of a gas. The explanation which the calorists offered of the production of heat by friction or compression was that some of the latent caloric was squeezed or ground out of the bodies concerned and became “sensible.” In the case of heat developed by friction, they supposed that the abraded portions of the material were capable of holding a smaller quantity of heat, or had less “capacity for heat,” than the original material. From a logical point of view, this was a perfectly tenable hypothesis, and one difficult to refute. It was easy to account in this way for the heat produced in boring cannon and similar operations, where the amount of abraded material was large. To refute this explanation, Rumford (Phil. Trans., 1798) made his celebrated experiments with a blunt borer, in one of which he succeeded in boiling by friction 26.5 ℔ of cold water in 2½ hours, with the production of only 4145 grains of metallic powder. He then showed by experiment that the metallic powder required the same amount of heat to raise its temperature 1°, as an equal weight of the original metal, or that its “capacity for heat” (in this sense) was unaltered by reducing it to powder; and he argued that “in any case so small a quantity of powder could not possibly account for all the heat generated, that the supply of heat appeared to be inexhaustible, and that heat could not be a material substance, but must be something of the nature of motion.” Unfortunately Rumford’s argument was not quite conclusive. The supporters of the caloric theory appear, whether consciously or unconsciously, to have used the phrase “capacity for heat” in two entirely distinct senses without any clear definition of the difference. The phrase “capacity for heat” might very naturally denote the total quantity of heat contained in a body, which we have no means of measuring, but it was generally used to signify the quantity of heat required to raise the temperature of a body one degree, which is quite a different thing, and has no necessary relation to the total heat. In proving that the powder and the solid metal required the same quantity of heat to raise the temperature of equal masses of either one degree, Rumford did not prove that they contained equal quantities of heat, which was the real point at issue in this instance. The metal tin actually changes into powder below a certain temperature, and in so doing evolves a measurable quantity of heat. A mixture of the gases oxygen and hydrogen, in the proportions in which they combine to form water, evolves when burnt sufficient heat to raise more than thirty times its weight of water from the freezing to the boiling point; and the mixture of gases may, in this sense, be said to contain so much more heat than the water, although its capacity for heat in the ordinary sense is only about half that of the water produced. To complete the refutation of the calorists’ explanation of the heat produced by friction, it would have been necessary for Rumford to show that the powder when reconverted into the same state as the solid metal did not absorb a quantity of heat equivalent to that evolved in the grinding; in other words that the heat produced by friction was not simply that due to the change of state of the metal from solid to powder.
Shortly afterwards, in 1799, Davy[2] described an experiment in which he melted ice by rubbing two blocks together. This experiment afforded a very direct refutation of the calorists’ view, because it was a well-known fact that ice required to have a quantity of heat added to it to convert it into water, so that the water produced by the friction contained more heat than the ice. In stating as the conclusion to be drawn from this experiment that “friction consequently does not diminish the capacity of bodies for heat,” Davy apparently uses the phrase capacity for heat in the sense of total heat contained in a body, because in a later section of the same essay he definitely gives the phrase this meaning, and uses the term “capability of temperature” to denote what we now term capacity for heat.
The delay in the overthrow of the caloric theory, and in the acceptance of the view that heat is a mode of motion, was no doubt partly due to some fundamental confusion of ideas in the use of the term “capacity for heat” and similar phrases. A still greater obstacle lay in the comparative vagueness of the motion or vibration theory. Davy speaks of heat as being “repulsive motion,” and distinguishes it from light, which is “projective motion”; though heat is certainly not a substance—according to Davy in the essay under discussion—and may not even be treated as an imponderable fluid, light as certainly is a material substance, and is capable of forming chemical compounds with ordinary matter, such as oxygen gas, which is not a simple substance, but a compound, termed phosoxygen, of light and oxygen. Accepting the conclusions of Davy and Rumford that heat is not a material substance but a mode of motion, there still remains the question, what definite conception is to be attached to a quantity of heat? What do we mean by a quantity of vibratory motion, how is the quantity of motion to be estimated, and why should it remain invariable in many transformations? The idea that heat was a “mode of motion” was applicable as a qualitative explanation of many of the effects of heat, but it lacked the quantitative precision of a scientific statement, and could not be applied to the calculation and prediction of definite results. The state of science at the time of Rumford’s and Davy’s experiments did not admit of a more exact generalization. The way was paved in the first instance by a more complete study of the laws of gases, to which Laplace, Dalton, Gay-Lussac, Dulong and many others contributed both on the experimental and theoretical side. Although the development proceeded simultaneously along many parallel lines, it is interesting and instructive to take the investigation of the properties of gases, and to endeavour to trace the steps by which the true theory was finally attained.
10. Thermal Properties of Gases.—The most characteristic property of a gaseous or elastic fluid, namely, the elasticity, or resistance to compression, was first investigated scientifically by Robert Boyle (1662), who showed that the pressure p of a given mass of gas varied inversely as the volume v, provided that the temperature remained constant. This is generally expressed by the formula pv = C, where C is a constant for any given temperature, and v is taken to represent the specific volume, or the volume of unit mass, of the gas at the given pressure and temperature. Boyle was well aware of the effect of heat in expanding a gas, but he was unable to investigate this properly as no thermometric scale had been defined at that date. According to Boyle’s law, when a mass of gas is compressed by a small amount at constant temperature, the percentage increase of pressure is equal to the percentage diminution of volume (if the compression is v/100, the increase of pressure is very nearly p/100). Adopting this law, Newton showed, by a most ingenious piece of reasoning (Principia, ii., sect. 8), that the velocity of sound in air should be equal to the velocity acquired by a body falling under gravity through a distance equal to half the height of the atmosphere, considered as being of uniform density equal to that at the surface of the earth. This gave the result 918 ft. per sec. (280 metres per sec.) for the velocity at the freezing point. Newton was aware that the actual velocity of sound was somewhat greater than this, but supposed that the difference might be due in some way to the size of the air particles, of which no account could be taken in the calculation. The first accurate measurement of the velocity of sound by the French Académie des Sciences in 1738 gave the value 332 metres per sec. as the velocity at 0° C. The true explanation of the discrepancy was not discovered till nearly 100 years later.
The law of expansion of gases with change of temperature was investigated by Dalton and Gay-Lussac (1802), who found that the volume of a gas under constant pressure increased by 1/267th part of its volume at 0° C. for each 1° C. rise in temperature. This value was generally assumed in all calculations for nearly 50 years. More exact researches, especially those of Regnault, at a later date, showed that the law was very nearly correct for all permanent gases, but that the value of the coefficient should be 1⁄173rd. According to this law the volume of a gas at any temperature t° C. should be proportional to 273 + t, i.e. to the temperature reckoned from a zero 273° below that of the Centigrade scale, which was called the absolute zero of the gas thermometer. If T = 273 + t, denotes the temperature measured from this zero, the law of expansion of a gas may be combined with Boyle’s law in the simple formula
pv = RT
(1)
which is generally taken as the expression of the gaseous laws. If equal volumes of different gases are taken at the same temperature and pressure, it follows that the constant R is the same for all gases. If equal masses are taken, the value of the constant R for different gases varies inversely as the molecular weight or as the density relative to hydrogen.
Dalton also investigated the laws of vapours, and of mixtures of gases and vapours. He found that condensible vapours approximately followed Boyle’s law when compressed, until the condensation pressure was reached, at which the vapour liquefied without further increase of pressure. He found that when a liquid was introduced into a closed space, and allowed to evaporate until the space was saturated with the vapour and evaporation ceased, the increase of pressure in the space was equal to the condensation pressure of the vapour, and did not depend on the volume of the space or the presence of any other gas or vapour provided that there was no solution or chemical action. He showed that the condensation or saturation-pressure of a vapour depended only on the temperature, and increased by nearly the same fraction of itself per degree rise of temperature, and that the pressures of different vapours were nearly the same at equal distances from their boiling points. The increase of pressure per degree C. at the boiling point was about 1⁄28th of 760 mm. or 27.2 mm., but increased in geometrical progression with rise of temperature. These results of Dalton’s were confirmed, and in part corrected, as regards increase of vapour-pressure, by Gay-Lussac, Dulong, Regnault and other investigators, but were found to be as close an approximation to the truth as could be obtained with such simple expressions. More accurate empirical expressions for the increase of vapour-pressure of a liquid with temperature were soon obtained by Thomas Young, J. P. L. A. Roche and others, but the explanation of the relation was not arrived at until a much later date (see [Vaporization]).