When the gun fires, and the bullet has passed the port, the gases drive the piston (35) and gas lever (29) downwards, and the momentum imparted causes them to swing back round the pivot (36), as shown by the dotted circle. The gas lever is brought up now by the bottom plate (91); and the retracting springs, compressed by the cross head of the long link (45) owing to the forward motion of the short arm of the gas lever, react and drive the gas lever into its forward position again.
| Figs. 17 and 18.—Colt Automatic Gun Mechanism. |
The rotary movement of the gas lever is converted into a reciprocating movement of the slide (86) by means of the gas lever connexion rod (31) pivoted at (32) to the gas lever, and at (87) to the slide.
The slide (86) is a nearly flat bar, travelling in guides in the receiver, extending from (14) to (87). It is slotted completely through longitudinally for nearly the whole of its length, this slot affording an opening through which work the cartridge extractor (82) and carrier (21). At its rear end it engages by means of a pin (14) in a cam slot (97) in the bottom rib of the bolt (13), and at (83) it bears the pivot of the cartridge extractor (82). Its rear end is enlarged below to form a cam lug (98), and on its right side are two projections (95) and (96), which work the feed lever (66).
| Fig. 19.—Colt Gun mounted. |
The feed wheel (61), over which passes the belt containing the cartridges, is actuated by a pawl “step-by-step” gear by means of the feed lever (66).
The carrier (21) is a long trip lever pivoted at (22), and provided with a spring dog (23) pivoted at (24).
The bolt (13) is a cylinder with a guide rib extending from its under surface. It is actuated by the slide by means of the pin (14) and cam slot (97) as already stated, and is bored through to take the striker or firing pin (18). The rear end of the latter projects slightly beyond the rear face of the bolt, being retained in this position by the spring (19). When this projecting end is pushed into the bolt, the point protrudes from the front of the bolt and fires the cartridge. The bolt, when the breech is locked, is held firm by two recoil blocks on the receiver (not shown), as is explained later. At the front of the bolt is an extractor (15) with a spring claw for extracting the fired case. (This is of course quite distinct from the cartridge extractor (82).) Ejection is effected by means of an ejector projecting into the path of the fired case.
The firing of the gun is performed by the cylindrical hammer (6) hollowed out in rear to contain the mainspring (7). When pushed back and cocked as shown in fig. 18, it is held during a portion of the operations of the mechanism by two detents working independently of each other—the sear (10) and the nose of the trigger (8). The former is automatically released by a trip lever (not shown) as soon as the breech is locked, leaving the hammer held by the trigger only. This is the position shown in fig. 18. The necessity for the two detents is explained later.
The hammer, when cocked, can also be permanently locked by the handle lock (2) actuated by a thumb-piece on the outside of the receiver. The air compressed in rear of the hammer, as the latter is driven back, passes through the tube (99) to the breech; and a puff of air is therefore blown through the barrel after every shot, clearing out fouling and unconsumed powder, and assisting to an appreciable extent to keep down the temperature of the barrel.