Steam is supplied to the two engines by one boiler of the Herreshoff steam generator type, with certain modifications, introduced by the designers, to insure the utmost certainty in working. It is of steel, the outside dimensions being 22 in. in diameter, 25 in. high, and weighs 142 lb. The fuel used is petroleum, and the working pressure 190 lb. per square inch.

The constructors consider the power developed by these engines very moderate, on account of the low piston speed specified in this particular case. In some small and light engines by the same makers the piston speed is as high as 1000 ft. per minute. The engines now illustrated form an interesting example of special designing, and Messrs. Ahrbecker, Son, and Hamkens deserve much credit for the manner in which the work has been turned out, the construction of such light engines involving many practical difficulties,--Engineering.


Mount Baker, Washington Territory, has shown slight symptoms of volcanic activity for several years. An unmistakable eruption is now in progress.


COMPLETE PREVENTION OF INCRUSTATION IN BOILERS.

The chemical factory, Eisenbuettel, near Braunschweig, distributes the following circular: "The principal generators of incrustation in boilers are gypsum and the so-called bicarbonates of calcium and magnesium. If these can be taken put of the water, before it enters the boiler, the formation of incrustation is made impossible; all disturbances and troubles, derived from these incrustations, are done away with, and besides this, a considerable saving of fuel is possible, as clear iron will conduct heat quicker than that which is covered with incrustation."

J. Kolb, according to Dingler's Polyt. Journal, says: "A boiler with clear sides yielded with 1 kil. coal 7.5 kil. steam, after two months only 6.4 kil. steam, or a decrease of 17 per cent. At the same time the boiler had suffered by continual working."

Suppose a boiler free from inside crust would yield a saving of only 5 per cent. in fuel (and this figure is taken very low compared with practical experiments) it would be at the same time a saving of 3c. per cubic meter water. If the cleaning of one cubic meter water therefore costs less than 3c., this alone would be an advantage.