The Pump (Figs 1, 5 and 6)—This consists of a cylindrical chamber, P, of bronze, bolted to a bracket on the frame, and cast in a piece, with the suction valve chamber, P, in which the valve, p, plays. It is surmounted by the distributing valve chamber P2. This latter is held by means of two nuts screwed on to the extremity of the rods, p3, connected with the shell, E, of the distributing-cock, E. In the shell, E, terminates, on one side, the pipe, p, through which enters the gas from the washer, and, on the other, the pipe i, that communicates with a feed-reservoir not shown in the cuts. The cock E, permits of the simultaneous regulation of the entrance of the gas and water. Its position is shown by an index e, passing over a graduated dial, e. From the distributing valve chamber, P2 the pipe, s, leads the mixture of water and gas under pressure into
The Saturator, S (Figs 1, 7 and 9)—This consists of a large copper vessel, s, affixed to the top of the frame through the intermedium of a bronze collar h, and a self closing bottom H. This latter is provided with two pipes, one of which, s, leads the mixture of water and carbonic acid forced by the pump, and the other, b, communicates with the siphons or bottles to be filled. The pipe, b, is not affixed directly to the bottom, but is connected therewith through the intermedium of a cock, r. The object of the broken form of this pipe is to cause the pressure to act according to the axis of the screw, r, which is maneuvered by the key, r2.
The water under pressure, having been forced into the vessel, S, is submitted therein to an agitation that allows it to dissolve a larger quantity of gas. Such agitation is produced by two pairs of paddles, J J, mounted at the extremity of an axle actuated by the wheel, A, through the intermedium of gearings, g and g.
The course of the operation in the saturator may be followed by an inspection of the water level, n, seen at the front and side in Figs. 2 and 3. This apparatus, in which the pressure reaches 4 to 6 atmospheres in the manufacture of Seltzer water or gaseous lemonade in bottles, and from 10 to 12 atmospheres in that of Seltzer water in siphons, is provided also with a pressure gauge, m, and a safety valve, both screwed, as is also the tube, n2, into a sphere, S, on the top of the saturator.
Apparatus for Using Carbonate of Lime (Figs 2, 3, and 10)—When chalk is acted upon by sulphuric acid, there is formed an insoluble sulphate which, by covering the chalk, prevents the action of the acid from continuing if care be not taken to constantly agitate the materials. This has led to a change in the arrangement of the generator in the apparatus designed for the use of chalk.
It consists in this case of a leaden vessel, D, having a hemispherical bottom set into a cylindrical cast iron base, K, and of an agitator similar to that shown in Fig. 11, for keeping the chalk in suspension in the water. These latter materials are introduced through the mouth, B (Fig. 3). Then a special receptacle, C, of lead, shown in detail in Fig. 10, and the cock, c, of which is kept closed, is filled with sulphuric acid. The acid is not introduced directly into the vessel, C, but is poured into the cylinder, C, whose sides contain numerous apertures which prevent foreign materials from passing into the siphon tube c, and obstructing it.
To put the apparatus in operation, the acid cock, c, is opened and the wheel, A, is turned, thus setting in motion both the pump piston, P, and the agitator, within S and D. Then the play of the pump produces a suction in the washers and from thence in the generator and causes the acid in the vessel, C, to flow into the generator through the leaden siphon tubes, c. Coming in contact with the chalk in suspension, the acid produces a disengagement of gas which soon establishes sufficient pressure to stop the flow of the acid and drive it back into the siphon tube. The play of the pump continuing, a new suction takes place and consequently a momentary flow of acid and a new disengagement of gas. Thus the production of the latter is continuous, and is regulated by the very action of the pump, without the operator having to maneuver an acid-cock. The latter he only has to open when he sets the apparatus in operation, and to close it when he stops it.
The arrangement of the washer is the same as in the preceding apparatus, save that a larger cylindrical copper reservoir, G', is substituted for the lower flask. The pump and saturator offer nothing peculiar.
A bent tube, u, which communicates with the generator, D, on one side, and with a cylindrical tube, V, ending in a glass vessel on the other, serves as a safety-valve for both the generator and the acid vessel.
The consumption of chalk is about 2.5 kilogrammes, and the same of acid, for charging 100 siphons or 150 bottles. The apparatus shown in the figure is capable of charging 600 siphons or 900 bottles per day.