Mr. Porter stops short in his discussion. He should have added a table giving the proportionate length of stroke, weight of parts, and number of revolutions required to produce the effect of an engine running at a high speed, without the least fraction of inequality in the strain on the crank, and then the sun would have fairly risen in the "dawn of a new era for the steam engine." But, as it is so very simple, we can all figure it out for ourselves.
In the diagram Mr. Porter gives, to illustrate the travel of the piston, he wets his finger and draws it over another term in the equation (a method of elimination not taught by Hutton, Davies, and other mathematicians). It is a quick way, but is it correct? He says, "the distance traveled by the piston is the versed sine of an angle formed by a line from the center of the crank pin, in any part of its stroke to the center of the circle described by the crank pin, leaving out of the calculation the angular vibration of the connecting rod." What he means by the "angular vibration," I do not know. He is wrong in the statement. If he will think of it he will see it. If he meant to say that the piston's travel was measured by the versed sine of the angle formed by the connecting rod and the line of horizontal centers, he is wrong again, yet nearer the truth than before, just as the proportion between the length of the connecting rod and the half diameter of the circle described by the crank pin. This can quickly be seen by supposing the connecting rod to be detached, and allowed to fall down on the center line, at any part of the stroke. If he understood this (as no doubt he did), he should not ignore the facts.
What I am aiming at is this. When a man attempts to demonstrate a thing mathematically, he must take into his calculation everything essentially connected with the problem, just exactly as it is, and not as he would have it; otherwise, he cannot, by any possibility, attain a correct result. When he claims, as now, the practicability of running engines at a high speed, I think he is claiming too much. Build an engine of proper materials, make it strong, and fit everything as it should be, balance crank and fly wheel to a nicety, keep everything snugly in its place, and the terrors of a quick stroke vanish.
S. W. H.
Test for White Lead.
Messrs. Editors:—I have read, with much interest, Dr. Chandler's colorimetric test of the purity of white lead, as published in the Scientific American sometime ago. I enclose another test, which, though not new, is of value to all using white lead on account of its simplicity and effectiveness. It has been in use here for nearly two years, and has been found reliable. Having never seen it in print, I have tried to put it in as simple words as possible.
Felix McArdle, Analytical Chemist.