If the mode of appearance of the image indicates that the plate has been correctly exposed, about half the remaining ammonia and bromide mixture may be added to the developer at once, and the action allowed to continue, with occasional rocking of the dish. If development proceeds satisfactorily and, in particular, if the chief details in the shadows begin to appear before the highest lights have become too opaque, it is not necessary nor advisable to add the last portion of the ammonia and bromide mixture, since the tendency to general fog and green fog is reduced when the proportion of ammonia is kept as low as possible. On the other hand, if the development flags and the appearance of shadow detail is a little tardy, the rest of the ammonia and bromide mixture must be added.
If the plate seems to be over-exposed, no more of the ammonia and bromide mixture should be added for some time, until it is seen whether the quantity already in the developer will suffice to complete development. If it seems that the over-exposure has been considerable, a further quantity of pyro solution (10 to 20 minims per oz.) and also of bromide solution (10, 20, or 30 minims per oz.) may be added with advantage. Development is then allowed to continue and the negative is examined from time to time; if it is seen that the opacity does not increase, or if sufficient detail in the deep shadows does not appear, further small quantities of the ammonia and bromide mixture may be added cautiously until the required result is obtained, waiting a little while to see the result of each small addition before adding more.
Teasels
By Carine Cadby.
When the plate behaves as if under-exposed, dilute the developer at once with half the quantity or an equal quantity of water, according to the degree of under-exposure indicated, and add the whole of the ammonia and bromide mixture. These modifications should check the rate at which the high-lights of the subject gain opacity, whilst accelerating the appearance of the middle tones and shadows. Should this effect not be produced, further quantities of ammonia and bromide mixture may be added or, in extreme cases, ammonia alone, and the developer may be still more diluted with water.
If any considerable parts of the image still show no detail, local development with a brush may be tried as a last resource. A soft camel's hair brush, preferably mounted in quill, is used. Some of the ammonia and bromide mixture is placed in a vessel and diluted with two or three times its volume of water. One corner or edge of the plate is raised so that the part to be treated is lifted out of the developer, the diluted ammonia and bromide mixture is applied rapidly with the brush, and the plate is allowed to drop gently back into the developer. The treatment may be repeated if necessary.
Should all these devices fail, the plate is hopelessly under-exposed.
Sometimes, when working with a diluted developer as just described, it happens that although all the necessary detail has been brought out, the image gains in opacity very slowly. Provided that all the required detail is visible, small quantities of pyro solution may be added in order to gain opacity more quickly.
PYRO-SODA DEVELOPMENT.
When sodium carbonate is used as the alkali in place of ammonia the developer acts somewhat more slowly and is less liable to produce fog, especially with very rapid plates, and there is very little tendency to produce green fog. On the other hand, variations are not so easily made in the composition of the developer. Some people find the absence of the smell of ammonia a decided advantage.