Plan For A Country Church.
At the request of several bishops and clergymen, we intend to publish from time to time in this magazine, architectural plans suitable for churches of moderate size and costliness. There are many churches of this kind, especially in small country places, required by the wants of the people, where an architect cannot be found, and where the materials, furniture, and other necessary parts or appendages of the sacred edifice must be of the cheapest possible kind. Generally speaking, churches of this sort are built and furnished without any regard to beauty or rubrical propriety. It is, however, just as cheap and easy to make them attractive, neat, and strictly ecclesiastical in their style and proportions as the contrary, if only proper plans and directions can be obtained. These we purpose to furnish after various styles of architecture, and suitable to the different exigencies and tastes of different places and persons. In so doing, we hope to supply a want that has long been felt, and to assist a great number of priests who are laboriously engaged in the meritorious but difficult task of building churches with but limited means for carrying out their plans.
Description.
The design which we have engraved in this number will give accommodation to two hundred and fifty persons seated, the area of the floor of the church being 41 x 25 feet in the clear, with a sanctuary of 12 x 16 feet, a sacristy 12 x 15 feet, and a porch to the front of the church sheltering the door against exposure. The confessional is placed in such a position that the comfort of the priest as well as the convenience of the people may be secured.
The church should be framed with good, stout sills 8x12 inch section, resting on a substantial wall of rubble masonry, where stone can be obtained, or of brick where this material becomes necessary, which wall should be carried deep enough to be unaffected by the frosts of winter, and raised one foot at least above the earth, a wall of rubble or brick being built along the centre to bear the joists of the floor. The joists should be (3 x 10) framed into the sills so that the top of the floor, when finished, may be twenty-eight inches, above the earth, giving four steps to the church, the floor of the sanctuary and sacristy being one step higher, and both on a level. The corner-posts should be 8 X 8 pine timber, and four intermediate posts of 4 x 8. under each principal of the roof. The plate on the top should be 4 x 8, and carried round the whole building except where the chancel intervenes, and care should be taken that all the scarfs of this piece of timber should be carefully made. The posts should all be braced with 4x6 pieces, and the walls studded with 4x4, so that, should it be deemed necessary, in particular localities, to render the building less susceptible to the changes of temperature, the inner space may be filled.
The roof should be framed as high as shown on the elevation, with a slope of 60° with the horizon, in order to obtain greater height to the interior and greater strength to the truss, with a collar about midway of the height, but not lower, and curved braces, resting on hammer beams projecting from the side-walls at the height of the plate, and a curved brace underneath this beam, bringing the strain of the truss as low as possible on the side-walls, but not incommoding the congregation.
Elevation