PLATE 30.
PLATE XXX.
WINDERS IN THE QUARTER-SPACE, STARTING FROM A NEWEL.
Fig. 1 shows the plan. There will be one baluster on the bottom step, and the remainder placed as shown. In planning stairs of this kind care must be taken not to let the newel obstruct the passage. No fixed rule can be laid down for the position of the newel; circumstances alone must regulate that; but the further the newel is brought round the more graceful will be the falling line of rail.
Fig. 2 is the elevation. Make C A equal the stretch-out of centre line of rail from C to A, Fig. 1, and C D equal C B, Fig. 1. Let B be 12 inches above the floor line; now draw the centre falling line from the joint at R at the top, and to strike the face of the newel level at the height of B, as shown by the dotted lines. Join R B for pitch of tangent B C. The tangent A B will be level, therefore the same length as on plan. Draw the joint at R square to the straight rail, and R P square to the tangent. Mark off along R P, R S to equal 5 5, Fig. 4.
Fig. 3 is the face mould for the top side of the plank. Draw the lines A E and N E at right angles, and make A E equal A E, Fig. 1, and N E equal B D, Fig. 2; join A N, which is the major axis; make C R equal C R above the springing at Fig. 2; add S S, Fig. 2, on to the end of shank, as shown by shaded part. The completion of the face mould will be understood.
Fig. 4 shows the sections. It will be noticed that the sections S and R are above the centre of plank. Make F S R, Fig. 2, equal A S R on the centre line of rail, Fig. 1, and make S S and R R below the falling at Fig. 2 equal R F and R O, Fig. 3. The difference between S and the falling line is what the section at S is above the centre of plank, while that between R and the falling line is what the section at R on the minor axis is above the centre of plank.
Fig. 5 shows the bevels for the bevelled joint at R. Draw H H to the same pitch as the bevel for the section C and draw C E square to H H and C N vertical; draw E D level through N; make C S and C S equal S S, Fig. 2, and join S D and S E for bevels T and S. To cut out the wreath, lay the face mould on the stuff, transfer the tangents on to it, mark off on each side of the tangent at A A 1, and on each side of the tangent at C C N, and on each side of R on the minor axis, ¼ of an inch more than half width of rail, marked P P, Fig. 4. Trace around through I P N inside and outside. Cut the wreath out square through the plank. Before bevelling the wreath, work the joint to the bevels T and S. The bevel T to be applied across the top and bottom, while the bevel S will be applied on the sides. S S is the extra length of stuff required on end of shank, as shown by shaded part on end of face mould. To get out the face mould for the under side, lay Fig. 3 on a thin piece of stuff and transfer the tangents and section lines on to it, and stick a bradawl through A S R C and mark off on each section the width of mould on the opposite side to Fig. 3. The shank will be the same amount shorter that Fig. 3 is longer.