BOOK I.
TRAPS FOR LARGE GAME.
owever free our forests may be from the lurking dangers of a tropical jungle, they nevertheless shelter a few large and formidable beasts which are legitimate and deserving subjects of the Trapper's Art. Chief among them are the Puma, or Cougar, Bear, Lynx, Wolf and Wolverine.
Although commonly taken in steel traps, as described respectively in a later portion of this work, these animals are nevertheless often captured by Deadfalls and other devices, which are well known to the professional Trapper, and which serve excellently in cases of emergency, or in the scarcity of steel traps.
THE DEAD-FALL.
There are several varieties of this trap, some of which are described in other parts of this volume. In general construction they all bear a similarity, the methods of setting being slightly changed to suit the various game desired for capture. For large animals, and particularly the Bear, the trap is sprung by the pressure of the animal's foot, while reaching for the bait. Select some favorite haunt of the Bear, and proceed to construct a pen of large stakes. These should consist of young trees, or straight branches, about three inches in diameter, and should be of such a length as to reach a height of four or five feet when set in the ground, this being the required height of the pen. Its width should be about two and a half or three feet; its depth, four feet; and the top should be roofed over with cross pieces of timber, to prevent the bait from being taken from above. A straight log, about eight inches in diameter, and six feet in length should now be rolled against the opening of the pen, and hemmed in by two upright posts, one on each side, directly on a line with the sides of the enclosure. Another log, or tree trunk, of the same diameter, and about fifteen or twenty feet in length, should next be procured. Having this in readiness, we will now proceed to the construction of the other pieces. In order to understand the arrangement of these, we present a separate drawing of the parts
as they appear when the trap is set (a). An upright post, is supplied at the upper end with a notch, having its flat face on the lower side. This post should be driven into the ground in the left hand back corner of the pen, and should be three feet or more in height. Another post (b) of similar dimensions, is provided with a notch at its upper end, the notch being reversed, i. e., having its flat side uppermost. This post should be set in the ground, outside of the pen, on the right hand side and on a line with the first. A third post (c), is provided with a crotch on its upper end. This should be planted outside of the pen on the right hand side, and on a line with the front. The treadle piece consists of a forked branch, about three feet in length, supplied with a square board secured across its ends. At the junction of the forks, an augur hole is bored, into which a stiff stick about three feet in length is inserted. This is shown at (h). Two poles, (d) and (e), should next be procured, each about four feet in length. These complete the number of pieces, and the trap may then be set. Pass the pole (d)
