Violin Making / 'The Strad' Library, No. IX.

by Walter H. Mayson

PLATE XXVI.

Then, before I fix the neck into the violin, I attach the fingerboard and nut—the latter in rough ebony, as I always work this neater with some wood over and above what I want. This fingerboard must be perfect in fit, put on with very hot, thin glue, and well cramped with three [No. 11] cramps, having wood guard [31] over fingerboard for protection. When set and hard next day, I prepare the end incision for the neck to enter, and proper elevation of the ebony, so that the correct angle for a bridge of fair average height may be obtained. I give you what is a fair average height—one and three-eighths of an inch; but there is no absolute rule as to this. What is here given is that which will suit the instrument just made, as I know by many constructed on similar lines. This height is got when the bridge is held down by the strings, and the measurement is from belly to middle of the arch of the bridge.

Your fingerboard must be at such an angle when the neck is fixed, that the end of it near bridge must measure exactly thirteen-sixteenths of an inch from belly to top of ebony; by this means your bridge, as described, will be just a nice height for clean fingering of the strings.

This brings me to fixing the neck, and I do it thus:—In the first place, I have to remember that the length from nut on the fingerboard, inner side, to the bridge, must be, when all is finished, thirteen inches exactly, and the angle as above. So I have to be very careful that too much is not taken out of the slot I have to finish, either in width or inner recess, as that, one or the other, would necessitate lowering the neck end, which is not what I want to do. First the knife, then the files (coarse ones), and, little by little, I get nearer and nearer to a fit, when I try angle and the straightness of the whole with the fiddle, using compasses to measure from inner point of purfling, upper corner, to corner of fingerboard on corresponding side, with their exact counterparts on the other; and testing height of fingerboard from belly. This is very weary work, and must be quite correctly done, or—well you will either hear of it again in words, or see your failure in the sweet smile which is more detestable than the severest frown.

But all is at length right; the neck is forced home, and I mark round the button, on to the superfluous wood of neck, its curve, so that I may not cut beyond when I thin the neck to its proper and final shape and thickness.

Many of you will, doubtless, be players of the fiddle, and to such, good, bad or indifferent, I need hardly say how much the disposition and general character of the neck of your instrument influences your performance on it. It is obviously quite impossible to lay down any rule or law, as to depth, width, or the curve at the end terminating at the button, for some will have this latter thin and abrupt, others less so, whilst a few insist on its being thick.

If people only knew how much the strength of the neck has to do with the tone of the instrument, they would leave to the maker or expert to determine what was best for it, either in the original making of the violin or in placing a new neck in an old one. But it is convenience—what we like and what we will have; so, in consequence, suffers the tone of the instrument.

You have a violin thick in wood: if I find on it a neck also heavy in material, to a certainty I have to register thin, woody tone; whereas, given a thinner neck there would be more vibration in it, and an undoubted impetus would be given to the somewhat inert body of the violin—its heavy timber being too much for the mass of air, which acts its part in that it moves in response to compulsion, but fails, in producing so feeble an agitation of the whole wood.

But, on the other hand, I find a thin neck attached to a thin body, and I also find a whole pack of wolves, hollow, rasping tone, and difficult of production—in fact, a wretched fiddle.

Then, as to width of fingerboard—a narrow one is often clung to as "so nice and handy," etc., but it is forgotten that the strings in consequence have to be brought closer together than clean fingering requires; and, moreover, the E string must, of necessity, be brought too near the edge of the ebony for firm stopping; so I have no sympathy whatever with a narrow or too thin fingerboard and neck.