Get a pistol which, when you grip the stock properly, has the barrel and your arm as nearly in a horizontal line as possible. Many makes of revolvers and automatic pistols have the stock much below the level of the barrel, which consequently is above the hand. This makes shooting more difficult; you are apt to cant the weapon to one side, and the recoil is more severe on your wrist. A man who holds a pistol properly does not need a big stock, even if he has a big hand.
For rough work, and in strong sunlight, a pistol is best blued. I temporarily paint the rib, etc., when target shooting on sunny days, with “sight-black.”
Revolver ammunition is usually made in the following calibres: .32, .38, .41, .44, .45, .455. Most of these can be had loaded with various smokeless powders, as King’s semi-smokeless, Riflite, Cordite, Walsrode, etc.
The Union Metallic Cartridge Company, U. S. A., have supplied me with great quantities of .44 “gallery ammunition,” loaded with both round and semi-round bullets. These have a small charge of black powder, and I should prefer this ammunition out of a Smith & Wesson Russian Model revolver for self-defence, as well as for competitions up to twenty yards, and I find it the most accurate for exhibition shooting. I believe most professional stage-shooters use it. It is a great pity this revolver is no longer made and can only be bought second-hand. If a second-hand one is otherwise good, a new barrel can be put to it. I suppose the various English makers of ammunition could supply “gallery” charges in any of their various calibre cartridges, but I know of none and should not advise the beginner to try loading this sort of ammunition in English cartridge-cases for himself. The dome of the cap is generally higher than in American cartridges; if, therefore, the small powder charge used in gallery ammunition be put in the case and the bullet pressed down, the bullet will come down on the dome, stop up the flash-hole, and cause a misfire. The way to obviate this is to take a wad of suitable calibre, make a hole in the centre, and push the wad down to the bottom of the cartridge before putting in the powder, so as to fill up the base of the cartridge and let the bullet “seat” on the powder, higher than the dome. Makers can do this properly, but an amateur may put the wad in too loosely, and a little powder get under the wad. The result would be that, on the shot being fired, the wad would be driven half-way up the barrel, and might at the next shot cause a burst.
Be sure to use only low-pressure powder, if you use smokeless, as high-pressure powders are dangerous in a “break-down” action revolver. Gallery ammunition in a .38 new model solid frame Smith & Wesson revolver gives good shooting.
Many people do not understand this difference in powder pressure, and injure their revolvers by experimenting with what become practically “blasting” instead of propelling charges.
CHAPTER III
CLEANING AND CARE OF PISTOLS