CHAPTER III.
COMPENSATING PENDULUMS.
As the pendulum is the means of regulating the time consumed in unwinding the spring or weight cord by means of the escapement, passing one tooth of the escape wheel at each end of its swing, it will readily be seen that lengthening or shortening the pendulum constitutes the means of regulating the clock; this would make the whole subject a very simple affair, were it not that the reverse proposition is also true; viz.; Changing the length of the pendulum will change the rate of the clock and after a proper rate has been obtained further changes are extremely undesirable. This is what makes the temperature error spoken of in the preceding chapter so vexatious where close timing is desired and why as a rule, a well compensated pendulum costs more than the rest of the clock. The sole reason for the business existence of watch and clockmakers lies in the necessity of measuring time, and the accuracy with which it may be done decides in large measure the value of any watchmaker in his community. Hence it is of the utmost importance that he shall provide himself with an accurate means of measuring time, as all his work must be judged finally by it, not only while he is working upon time-measuring devices, but also after they have passed into the possession of the general public.
A good clock is one of the very necessary foundation elements, contributing very largely to equip the skilled mechanic and verify his work. Without some reliable means to get accurate mean time a watchmaker is always at sea—without a compass—and has to trust to his faith and a large amount of guessing, and this is always an embarrassment, no matter how skilled he may be in his craft, or adept in guessing. What I want to call particular attention to is the unreliable and worthless character of the average regulator of the present day. A good clock is not necessarily a high priced instrument and it is within the reach of most watchmakers. A thoroughly good and reliable timekeeper of American make is to be had now in the market for less than one hundred dollars, and the only serious charge that can be made against these clocks is that they cost the consumer too much money. Any of them are thirty-three and a third per cent higher than they should be. About seventy-five dollars will furnish a thoroughly good clock. The average clock to be met with in the watchmakers’ shops is the Swiss imitation gridiron pendulum, pin escapement, and these are of the low grades as a rule; the best grades of them rarely ever get into the American market. Almost without exception, the Swiss regulator, as described, is wholly worthless as a standard, as the pendulums are only an imitation of the real compensated pendulum. They are an imitation all through, the bob being hollow and filled with scrap iron, and the brass and steel rods composing the compensating element, along with the cross-pieces or binders, are all of the cheapest and poorest description. If one of these pendulums was taken away from the movement and a plain iron bob and wooden rod put to the movement, in its place, the possessor of any such clock would be surprised to find how much better average rate the clock would have the year through, although there would then be no compensating mechanism, or its semblance, in the make-up of the pendulum. In brief, the average imitation compensation pendulum of this particular variety is far poorer than the simplest plain pendulum, such as the old style, grandfather clocks were equipped with. A wood rod would be far superior to a steel one, or any metal rod, as may be seen by consulting the expansion data given in the previous chapter.
Many other pendulums that are sold as compensating are a delusion in part, as they do not thoroughly compensate, because the elements composing them are not in equilibrium or in due proportion to one another and to the general mechanism.
To all workmen who have a Swiss regulator, I would say that the movement, if put into good condition, will answer very well to maintain the motion of a good pendulum, and that it will pay to overhaul these movements and put to them good pendulums that will pretty nearly compensate. At least a well constructed pendulum will give a very useful and reliable rate with such a motor, and be a great help and satisfaction to any man repairing and rating good watches.
The facts are, that one of the good grade of American adjusted watch movements will keep a much steadier rate when maintained in one position than the average regulator. Without a reliable standard to regulate by, there is very little satisfaction in handling a good movement and then not be able to ascertain its capabilities as to rate. Very many watch carriers are better up in the capabilities of good watches than many of our American repairers are, because a large per cent of such persons have bought a watch of high grade with a published rate, and naturally when it is made to appear to entirely lack a constant rate when compared with the average regulator, they draw the conclusion that the clock is at fault, or that the cleaning and repairing are. Many a fair workman has lost his watch trade, largely on account of a lack of any kind of reliable standard of time in his establishment. There are very few things that a repairer can do in the way of advertising and holding his customers more than to keep a good clock, and furnish good watch owners a means of comparison and thus to confirm their good opinions of their watches.
We have along our railroads throughout the country a standard time system of synchronized clocks, which are an improvement over no standard of comparison; but they cannot be depended upon as a reliable standard, because they are subject to all the uncertainties that affect the telegraph lines—bad service, lack of skill, storms, etc. The clocks furnished by these systems are not reliable in themselves and they are therefore corrected once in twenty-four hours by telegraph, being automatically set to mean time by the mechanism for that purpose, which is operated by a standard or master clock at some designated point in the system.
Now all this is good in a general way; but as a means to regulate a fine watch and use as a standard from day to day, it is not adequate. A standard clock, to be thoroughly serviceable, must always, all through the twenty-four hours, have its seconds hand at the correct point at each minute and hour, or it is unreliable as a standard. The reason is that owing to train defects watches may vary back and forth and these errors cannot be detected with a standard that is right but once a day. No man can compare to a certainty unless his standard is without variation, substantially; and I do not know of any way that this can be obtained so well and satisfactorily as through the means of a thoroughly good pendulum.
Compensating seconds pendulums are, it might be said, the standard time measure. Mechanically such a pendulum is not in any way difficult of execution, yet by far the greater portion of pendulums beating seconds are not at all accurate time measures, as independently of their slight variations in length, any defects in the construction or fitting of their parts are bound to have a direct effect upon the performance of the clock. The average watchmaker as a mechanic has the ability to do the work properly, but he does not fully understand or realize what is necessary, nor appreciate the fact that little things not attended to will render useless all his efforts.
The first consideration in a compensated pendulum is to maintain the center of oscillation at a fixed distance from the point of suspension and it does not matter how this is accomplished.