U, one of the blocks (the other not shown) to keep the bottom of the box from the ground, when the four legs L L L L, are unscrewed from the four corners of the box.
X X B D, the front of the box; e, the alighting board, four inches wide, extending the whole length from F to F; X 2, shows a small ledge to keep the wet from entering the bee-box, and X I, one of the slides s, drawn out, and extending beyond the end of the box; the other half slide, s, on the left hand side, not drawn out in the sketch, the part under X 1, shows the opening for the ingress and egress of the bees.
R, one of the two pieces of red cedar at the inside of the box, fixed at the ends, E F. E F. The Q Q, quadrants being made to work between the red cedar and the outer case or box; v v, the fillet fixed in the length of the box, on a level with the tops of red cedar; c d, the holes for the bolts b b, in the table I J.
W W, pieces of perforated zinc laid upon the tops of the bee-frames resting on the fillets, v v.
1, 2, 3, 4, 5, 6, six of the 15 grooves, half an inch deep, 9-1/2 long, and 1-1/2 of an inch broad, formed on the floor-board: the holes shown in the floor-board above the figures being made for the reception of the two pins, a b, in the observation-frame. No. 8, shows the "division-frame" run into the eighth groove of the floor-board, and No. 14 and 15, the bee-frames run into their respective grooves, and the 1-1/8 of an inch openings in the back closed by the slips of tin, q q q q, &c.
Y Y, the bar of mahogany with corresponding grooves, X X X X, &c. to those on the floor-board, at 1, 2, 3, 4, 5 and 6, and 15-2/8 holes for the top bolt, r, of the observation-frame, Z, to fix into. t, t, t, the screw nuts at the backs of the bee-frames, &c., for the screw at the end of the spindle, S, to work into, and thus hold and draw out of the grooves the bee-frames; w, the bee-frame containing comb and bees, drawn partly into the observation-frame, Z.