Our illustration shows one expedient for the remedy of the misfortunes we have named. A warp or cable is faked down upon the deck in lengths equal to that of the required rudder, all the parts are then so closely pressed together that it resembles a board of the required breadth; it is then stiffened by longitudinal and cross bars, a weight is attached to the bottom, and a tiller projects aft, from the extremity of which the steering tackles (A) lead in over each quarter. When lowered into its place, the heel is confined to the stern-post by chains or hawsers leading to the gangway on either side, and in the present instance ropes are reeved through the gudgeons on the stern-post. Sometimes two parts of the cable are left longer than the rest to come up the rudder trunk and form the neck of the rudder, a short spar passed through the bight on deck serves to suspend the whole. Very frequently, however, when the rudder goes, the gudgeons, and perhaps also part of the stern-post, are carried away, and it then becomes necessary to devise some plan which shall supply their loss.
Several expedients are given in the Nautical Magazine for 1836, and from these we extract two or three examples. A spar, such as the spanker-boom or jibboom, is first passed over the stern, secured to the centre of the taffrail by temporary “partners,” and to the heel of the stern-post by stout guys leading forward to the gangways on either side; the gaff is then fitted on this, just as it would be on a mast, and one of the smallest and stoutest storm staysails is laced, with the head downwards, to the upright spar, and also to the gaff, the foot of the sail being cut off, if it be too large. It is then hauled down to the lower end by a halyard previously reeved, and the gaff, which should go a little below the surface of the water, is hoisted until the sail sits “as flat” as a board. If greater power is thought necessary, the outer end of the gaff can be sawn vertically down the centre, and boards clinched in, as shown in the sketch (Fig. 3); or either the sail or boards might be used separately. The ship is steered by guys leading from near the end of the gaff over each quarter. Sometimes the principle of the steering oar is adopted: a spar, with planks fastened on its outer end, is got over, and the foremost end is fitted to the stern by ring-bolts or lashings, so as to allow it to work freely without too much play. The outer end is kept down either by a lower guy or by a piece of pig ballast or other weight; and if a topping-lift be attached, leading to a boom over the stern and thence to the mizen topmast-head, the oar may be lifted out of the water when one stroke has been completed, carried back again to the other side, and thus bring the ship’s head round by a succession of sweeps.
Sometimes it is necessary to make a temporary stern-post, and the spare lower cap (which, however, we may remark, is generally stowed away where it is least likely to be found on an emergency) can be fitted on this by enlarging the masthead hole and securing it, as before, by lower guys. A topmast, with its heel upwards, may be passed down through it, and such additional spars or planking bolted on as will give the needful increase of breadth. The surface should be as smooth as circumstances permit, so that the water may glance off readily; the fid-hole will then receive the tiller, but the spar must be well banded or lashed round to prevent its splitting with the strain, or perhaps breaking off where the sheave-hole weakens it.
Scarfing or fishing of broken spars.