| 1 | Light earth, mixed with sand | 11 | pounds. |
| 2 | Common earth | 12 | |
| 3 | Strong sand | 15 | |
| 4 | Clay, or fat earth | 16 | |
| 5 | Old and good masonry | 18 | |
| 9 | Rock | 20 |
The following rule is however laid down by Belidor, and generally adopted, if it be intended that the mine shall produce its maximum or greatest effect: multiply the line of least resistance, expressed in feet, by 300, the product will be the charge in pounds.
In making mines of any kind, the following remarks may be of service.
The best form for the chamber would be spherical; but from the difficulty of its construction, it is always made a cube, of one inch larger dimensions than the box to contain the powder.
The chamber must not be made in the prolongation of the branch of the mine, but at one side, and lower than the level of the branch, if the soil be dry; but higher if it be wet.
One cubic foot will contain 75 lbs of powder; upon which principle the size of the case to contain the powder must be regulated. The auget is generally one inch square interior dimensions, and the end of it must reach the centre of the chamber; where the saucisson must be fastened, to prevent its being easily pulled out.
The branch of the mine to be sprung must be closed in the strongest manner by doors well secured by props, and must be stopped with earth or rubbish to a distance, taken in a straight line, equal to 1¹⁄₂ times the line of least resistance.
In proportioning the length of saucisson, in order that any number of mines may be fired at the same instant, a return of a right angle is generally reckoned equal to 4 inches in a right line.
The first step in making a mine, whether for attack or defence, is to sink a shaft to the depth of the bottom of the gallery, having two of its sides in the direction of the sides of the gallery. These shafts should be where the galleries are to cross each other, or in the centre of the length of gallery to be made. These shafts should never be further apart than 40 or 50 fathoms; for it is found, that the air is not fit for respiration in the larger galleries at a greater distance from the shaft than 25 fathoms; at 20 fathoms in those of medium dimensions; and at 15 in the smallest.
The rectangular frames used in sinking a shaft are commonly placed 4 feet asunder; and in the galleries they are only 3 feet. A gallery intended to be lined with masonry, must be 7 feet high and 6 feet wide, in order that it may be when finished, 6 feet high and 3 feet wide.