Common Minerals and Rocks

by William O. Crosby

Stratified rocks generally show the stratification in parallel lines or bands differing in color, composition, etc.; but nothing like this can be detected in our specimens of conglomerate; and the question might be asked, How do we know that this is a stratified rock? In answer, it can be said that our hand-specimens appear unstratified simply because the rock is so coarse; but when we look at large masses, and especially when we see it in place in the quarry, that parallel arrangement of the material which we call stratification is usually very evident; and we often see precisely the same thing in gravel banks. It is, however, wholly unnecessary that we should see the stratification in order to know certainly that this is a stratified or aqueous rock, because the forms of the pebbles show very plainly that they have been fashioned and deposited by moving water; and we have in the smallest specimen proof positive that our conglomerate is a consolidated sea-beach.

Conglomerate shows the same variations in composition and texture as gravel; it may be composed of almost any kind of material in pebbles of almost any size. We recognize two principal varieties of conglomerate based on the forms of the pebbles; if, as is usual, these are well rounded and water-worn, the rock is true pudding-stone (specimen 29); but, if they are angular, or show but little wear, it is called breccia.

(2) Arenaceous Group.—The conglomerate group passes insensibly into the arenaceous group; for, from the coarsest gravel to the finest sand, the gradation is unbroken, and every sandstone is merely a conglomerate on a small scale.

Sand.—Like gravel, sand may be of almost any composition, but as a rule it is quartzose; quartz, on account of its hardness and the absence of cleavage, being better adapted than any other common mineral to form sand. Where the composition of a sand is not specified, a quartzose sand is always understood. By examining a typical sand with a lens, and noting the glassy appearance of the grains, and then testing their hardness on a piece of glass, which they will scratch as easily as quartz, the pupil is readily convinced that each grain is simply an angular fragment of quartz. Specimen 30.

Sandstone.—Consolidated sand. In proving this, children will notice first the granular or sandy appearance of the sandstone; and then, with the lens, that the grains in the sandstone have the same forms as the sand-grains. The stratification cannot be seen very distinctly in our hand-specimens, but in larger masses it is usually very plain, as may be observed in the blocks used for building, and still better in the quarries. However, even if the stratification were not visible to the eye, we could have no doubt that sandstone is a mechanically formed stratified rock; because the form of the grains, just as in the conglomerate, tells us that. Many sandstones, too, contain the fossil remains of plants and animals, and these are always regarded as affording positive proof that the rocks containing them belong to the aqueous or stratified series.

There are many varieties of sandstone depending upon differences in composition, texture, etc., but we have not space to notice them in detail. In sandstone, just as in sand, quartz is the predominant constituent, although we sometimes find varieties composed largely or entirely of feldspar, mica, calcite, or other minerals. Specimen 31 is an example of the architectural variety known as freestone, which is merely a fine-grained, light-colored, uniform sandstone, not very hard, and breaking with about equal freedom in all directions. The consolidation of sandstones is due chiefly to chemical action. The cementing materials are commonly either: ferruginous (iron oxides), giving red or brown sandstones; calcareous, forming soft sandstones, which effervesce with acid if the cement is abundant; or siliceous, making very strong, light-colored sandstones. Ferruginous sandstones are the most valuable for architectural purposes; for, while not excessively hard, they have a very durable cement. Siliceous sandstones are too hard; and the calcareous varieties crumble when exposed to the weather because the cement is soluble in water containing carbon dioxide, as all rain-water does. Specimen 32 is a good example of a ferruginous sandstone, and it is coarse enough so that we can see that each grain of quartz is coated with the red oxide of iron. The mica scales visible here and there in this specimen are interesting as showing that the grains are not necessarily all quartz; and it is important to observe that the mica was not made in the sandstone, but, like the quartz, has come from some older rock.

Quartzite.—This rock is simply an unusually hard sandstone. Now the hardness of any rock depends upon two things: (1) the hardness of the individual grains or particles; and (2) the firmness with which they are united one to another. Therefore, the hardest sandstones must be those in which grains of quartz are combined with an abundant siliceous cement; and that is precisely what we have in a typical quartzite, such as specimen 33. Quartzite is distinguished, in the hand-specimen, from ordinary quartz by its granular texture (compare specimens 15 and 33); and of course in large masses the stratification is an important distinguishing feature.

3. Argillaceous group.—Just as the conglomerate group shades off gradually into the arenaceous group, so we find it difficult to draw any sharp line of division between the arenaceous group and the argillaceous, but we pass from the largest pebble to the most minute clay-particle by an insensible gradation. For the sake of convenience, however, we draw the line at the limit of visibility, and say that in the true clay and slate the individual particles are invisible to the naked eye; in other words, these rocks have a perfectly compact texture, while the two preceding groups are characterized by a granular texture. Although clay, like sand and gravel, may be of almost any composition, yet it usually consists chiefly, often entirely, of the mineral kaolin. The reason for this is easily found. Quartz resists both mechanical and chemical forces, and is rarely reduced to an impalpable fineness; but all the other common minerals, such as feldspar, hornblende, mica, and calcite, on account of their cleavage and inferior hardness, are easily pulverized; but it is practically impossible that this should happen without their being broken up chemically at the same time. Decomposition follows disintegration; and, while calcite is completely dissolved and carried away, the other minerals are reduced, as we have seen, to impalpable hydrous silicates of aluminum, i.e., to kaolin. Hence, we find that the fragmental rocks are composed principally of two minerals, quartz and kaolin,—the former predominating in the conglomerate and arenaceous groups, and the latter in the argillaceous group.

Clay.—That kaolin is the basis of common clay is proved by the argillaceous odor, which is so characteristic of moist clay. Pure kaolin clay is white and impalpable, like China clay; but pure clays are the exception. They often become coarse and gritty by admixture with sand, forming loam; and they also usually contain more or less carbonaceous matter, which makes black clays; or more or less ferrous oxide, which makes blue clays; or more or less ferric oxide, which makes red, brown, and yellow clays. By mixing these coloring materials in various proportions, almost any tint may be explained. Clays are sometimes calcareous, from the presence of shells and shell-fragments or of pulverized limestone. These usually effervesce with acid, and are commonly known as marl. It is the calcareous material in a pulverulent and easily soluble condition that makes the marls valuable as soils.

Slate.—Consolidated clay. The compact texture and argillaceous odor are usually sufficient to prove this. To get the odor we need simply to breathe upon the specimen, and then smell of it. We find all degrees of induration in clay. It sometimes, as every one knows, becomes very hard by simple drying; but this is not slate, and no amount of mere drying will change clay into slate; for, when moistened with water, the dried clay is easily brought back to the plastic state. To make a good slate, the induration must be the result of pressure, aided probably to some extent by heat. True slate, then, is a permanently indurated clay which will not soak up and become soft when wet.