This means that he hermetically sealed himself inside of a craft, shaped like two upper turtle shells joined together—hence the name of the Turtle. He had entered through the orifice at the top, whence the head of the turtle usually protrudes. This before sinking he had covered and made water-tight by screwing down upon it a brass crown or top like that to a flask. Within he had enough air to support him thirty minutes. The vessel stood upright, not flat as a turtle carries himself. It was maintained in this position by lead ballast. Within the operator occupied an upright position, half sitting, half standing. To sink water was admitted, which gathered in the lower part of the boat, while to rise again this was expelled by a force pump. There were ventilators and portholes for the admission of light and air when operating on the surface, but once the cap was screwed down the operator was in darkness.
In this craft, which suggests more than anything else a curiously shaped submarine coffin, Lee drifted along by the side of the ship, navigating with difficulty with his single oar and seeking vainly to find some spot to which he might affix his magazine. A fact which might have disquieted a more nervous man was that the clockwork of this machine was running and had been set to go off in an hour from the time the voyage was undertaken. As to almost anyone in that position minutes would seem hours, the calmness of sailor Lee's nerves seems to be something beyond the ordinary.
When he finally abandoned the attempt on the Eagle he started up the bay. Off Governor's Island he narrowly escaped capture.
When I was abreast of the Fort on the Island three hundred or four hundred men got upon the parapet to observe me; at length a number came down to the shore, shoved off a twelve oar'd barge with five or six sitters and pulled for me. I eyed them, and when they had got within fifty or sixty yards of me I let loose the magazine in hopes that if they should take me they would likewise pick up the magazine and then we should all be blown up together. But as kind providence would have it they took fright and returned to the Island to my infinite joy.... The magazine after getting a little past the Island went off with a tremendous explosion, throwing up large bodies of water to an immense height.
During the last quarter of the eighteenth and during the first half of the nineteenth century France was the chief centre for the activities of submarine inventors. However, very few of the many plans put forward in this period were executed. The few exceptions resulted in little else than trial boats which usually did not live up to the expectations of their inventors or their financial backers and were, therefore, discarded in quick order. In spite of this lack of actual results this particular period was of considerable importance to the later development of the submarine. Almost every one of the many boats then projected or built contained some innovation and in this way some of the many obstacles were gradually overcome. Strictly speaking the net result of the experimental work done during these seventy-five years by a score or more of men, most of whom were French, though a few were English, was the creation of a more sane and sound basis on which, before long, other men began to build with greater success.
The one notable accomplishment of interest, especially to Americans, was the submarine built in 1800-01 by Robert Fulton. Fulton, of course, is far better known by his work in connection with the discovery and development of steam navigation. Born in Pennsylvania in 1765, he early showed marked mechanical genius. In 1787 he went to England with the purpose of studying art under the famous painter West, but soon began to devote most of his time and energy to mechanical problems. Not finding in England as much encouragement as he had hoped, he went, in 1797, to Paris and, for the next seven years, lived there in the house of the American Minister, Joel Barlow.
As soon as he had settled down in France, he offered his plans of a submarine boat which he called the Nautilus to the French Government. Though a special commission reported favourably on this boat, the opposition of the French Minister of the Marine was too strong to be overcome, even after another commission had approved a model built by Fulton. In 1800, however, he was successful in gaining the moral and financial support of Napoleon Bonaparte, then First Consul of the French Republic.
Fulton immediately proceeded to build the Nautilus and completed the boat in May, 1801. It was cigar-shaped, about seven feet in diameter and over twenty-one feet in length. The hull was of copper strengthened by iron ribs. The most noticeable features were a collapsible mast and sail and a small conning tower at the forward end. The boat was propelled by a wheel affixed to the centre of the stern and worked by a hand-winch. A rudder was used for steering, and increased stability was gained by a keel which ran the whole length of the hull.
