25. Certain utensils are required for the beating of the eggs used in cakes. If they are to be beaten separately before being put into the mixture, a bowl and a rotary egg beater should be provided. In case the eggs are to be separated and the whites beaten alone, a flat dish, such as a platter or a soup plate, and an egg whip are the most satisfactory.
26. The kind of pan required for the baking of cakes depends entirely on the kind of cake that is to be prepared. Fig. 1 shows the types of pans for which the housewife will have the most use. The square pan at the left is suitable for any kind of cake that is to be baked in the form of a loaf. In front of this is a layer-cake pan with a removable bottom. This type of layer-cake pan is the most satisfactory, for the cake may be lifted right out of the pan rim on the cake-pan bottom and the bottom then easily removed from the cake after it has been placed on the cooler. Of course, pans without false bottoms may also be used successfully with a little care. The large flat pan at the right is a pan for the baking of all kinds of cookies. On this is shown a round pan having a removable bottom, to the center of which is attached a tube. Sponge cakes, although they may be baked in loaf-cake pans, are generally baked in a pan of this kind. Pans for individual cakes range in size from large muffin pans, like the one shown at the right front, to pans that produce cakes very small in size.
PROCEDURE IN CAKE MAKING
PREPARATION OF INGREDIENTS
27. In cake making, as in the preparation of other dishes, a systematic plan must be followed if good results are desired. A housewife cannot expect to have a successful cake if she has to stop during the mixing to get some of the ingredients or some of the utensils ready. Before the mixing is begun, all the utensils and ingredients should be collected and any of the ingredients that require special preparation should be prepared. Then, if the recipe is correct, if the ingredients are measured accurately and combined correctly, and if the baking is done properly, success in cake making is assured.
28. The first thing to be done, when a cake is to be made, is to read the recipe to determine just what is required and to find out whether all the ingredients called for are in supply. With this done, all the utensils should be placed conveniently on the table and the ingredients collected and measured. Some authorities advise the weighing of the ingredients in cake because weight is always regarded as more accurate than measure. If a recipe calls for weights, it will be found easier to use them than to try to change them to measure; but when a recipe requires measures, and does not state weights, it would be unwise to attempt to use scales for measuring.
29. The measuring of the fat often requires a little attention. For instance, if only 1/4 cupful of butter or some other fat is required, it may perhaps be more convenient to measure it with a tablespoon than with a cup. Otherwise, unless the recipe calls for melted fat, the fat should be measured by pressing it down tight into the cup until it reaches the mark indicating the required amount. If the fat is hard and cold, as is usually the case when it is first taken from the refrigerator or other cold place, it will be difficult to cream. A good plan is to let the fat stand until it is 70 degrees Fahrenheit, or ordinary room temperature, before the mixing is begun.
30. The dry ingredients used in cakes include the sugar, flour, baking powder, spices, etc. Granulated sugar seldom requires any preparation except measuring. However, sugar other than granulated, particularly brown sugar and pulverized sugar, should be rolled with a rolling pin and then sifted in order to free it from any lumps it might contain. Flour should be sifted once before measuring and again with the baking powder, or soda and cream of tartar, and salt in order to mix them. Other dry ingredients, such as spices and occasionally pulverized sugar, may also be sifted with the flour and other dry ingredients. If the dry leavening agent appears to be lumpy when the cover is removed from the can, it should be worked smooth with a spoon and sifted before it is measured. A very small mesh wire sieve may be used for this purpose.