PROCEDURE IN CONFECTION MAKING
COOKING THE MIXTURE
53. WEATHER CONDITIONS.--If uniformly good results are desired in candy making, certain points that determine the success or failure of many candies, although seemingly unimportant, must be observed. Among these, weather conditions form such a large factor that they cannot be disregarded. A cool, clear day, when the atmosphere is fairly dry, is the ideal time for the making of all kinds of candies. Warm weather is not favorable, because the candy does not cool rapidly enough after being cooked. Damp weather is very bad for the making of such candies as the creamy ones that are made with egg white and that are desired to be as soft as possible and still in condition to handle. In view of these facts, candy should be made preferably on days when the weather is favorable if the element of uncertainty, so far as results are concerned, would be eliminated.
54. COMBINING THE SUGAR AND LIQUID.--The proportion of liquid and sugar to use in making candy varies to some extent with the kind of ingredients used and with the quantity of candy being made. In the making of quantities up to several pounds, the usual proportion is one-third as much liquid as sugar, but with larger amounts of sugar the quantity of liquid may be slightly decreased.
With the quantities decided on, mix the sugar and liquid and put them over the fire to boil. Stir at first to prevent the sugar from settling and burning, continuing the stirring either constantly or at intervals until the boiling begins. At this point, discontinue the stirring if possible. Mixtures that do not contain milk usually require no further stirring, and many times stirring is unnecessary even in those which do contain milk; but whenever any stirring is required, as little as possible should be done. The rule that applies in this connection is that the sugar should be entirely dissolved before the boiling begins and that all unnecessary agitation should then cease.
55. BOILING THE MIXTURE.--When the mixture begins to boil, wash down the sides of the kettle with a small cloth wet with clean water. This treatment should not be omitted if especially nice candy is desired, for it removes all undissolved sugar and helps to prevent crystallization later. In case merely sugar and water make up the ingredients, a cover may be placed on the kettle; then the steam that is retained will keep any sirup that may splash on the sides from crystallizing. This cannot be done, however, with mixtures containing milk and butter, for they will in all probability boil over.
56. The boiling of candy should be carried on quickly, for slow boiling often proves a disadvantage. A sugar-and-water mixture may, of course, be boiled more rapidly than any other kind, because there is not the danger of its boiling over nor of burning before the water is evaporated that there is with a mixture containing material that may settle and burn. It should be remembered that candy does not begin to burn until the water has entirely evaporated.
57. The length of time candy should boil is also a matter to which attention should be given. This depends somewhat on the kind that is being made, but largely on the rapidity with which the boiling is carried on. Thus, to time the boiling of candy is the most uncertain way of determining when the boiling has continued long enough. The inaccuracy of measurement, the size and shape of the pan, and the rate of speed in boiling cause a variation in the time required. Consequently, it would be rather difficult for the same person to get identical conditions twice and much more difficult for two persons to produce the same results.
58. TESTING CANDY.--Since accurate results cannot be obtained by timing the boiling of candy, other tests must be found that will be reliable. As has already been stated, a thermometer is perhaps the most accurate means that can be adopted for this purpose. However, if one is not available, the testing of a small quantity of the hot mixture by cooling it in cold water will be found to be fairly accurate. Ice water is not necessary nor particularly desirable for this kind of testing. In fact, water just as it comes from the faucet is the best, as it is quickly obtained and its temperature will not vary greatly except in very hot or very cold weather. Of course, to make an extremely accurate test of this kind, it would be necessary always to have the water at the same temperature, a condition that can be determined only by testing the temperature, but such accuracy is not usually required.