Quick-match.
3. Quick-match.—The purpose of the Quick-match is similar to that of touch-paper, but chiefly used to form the inside of leaders; it is generally made of cotton-wick, (such as is usually made use of in the manufacture of candles) impregnated with nitre. It is made of several sizes, from one to six threads, as is most suited to the pipes, or articles for which it is designed. The pipes must be sufficiently large to receive the match easily, as its quality will be much diminished by its breaking. The following is the best method of making this match:—Having distributed the cottons into the number of threads requisite for your purpose, coil it very lightly into a flat bottomed copper or earthen pan, then pour in a part of the salt-petre and liquor, and boil them together about twenty minutes, after which coil it again into another pan and put to it the remainder of the liquor, then put in some meal powder, and well mix it with the liquid; after which place the pan beneath the wooden frame ([fig. 12]) and tying one end of the cotton to one side of the frame, then by one hand by means of the handle (A) turn the frame round while you let the cotton pass through the other, holding it very lightly, and at the same time keeping your hand full of the wet powder; if the powder is too wet to stick to the cotton put more in the pan, so as to keep a supply until the match is all wound up; you may wind it as close on the frame as you please, providing it do not stick together; when the frame is full take it off the joints and sift dry meal powder on both sides the match, till it appears quite covered, afterwards hang it in some warm place to dry, which, if it be in summer, will be effected in a few days, but if it be in winter it will be a fortnight before it is fit for use; when it is perfectly dry, cut it along the outside of one of the side-pieces of the frames, and tie it up in skains for use.