To make Touch-Paper.

2. To Make Touch-Paper.—Dissolve a quantity of salt-petre in vinegar or any other acid, more or less of the salt-petre according as you would have your paper to burn slow or fast; then dip into this solution some thin blue paper, let it be well saturated, then take it out, and dry it for use. If, on trial, it is not found to burn properly, or if it blazes on being set on fire, it is an indication that your solution is too weak; you must therefore strengthen it by adding more of the nitre, and the paper must be passed through again. On the application of this paper to fire-works, two modes are in use:—For small articles, or such as are choaked (to be hereafter explained) tie a piece round the orifice with thread or fine twine, leaving enough of the paper at the end to form a small tube, in which is put some mealed gunpowder, and the paper is then twisted over it, and ready for firing.

For larger articles, as Rockets, Roman Candles, &c. the paper, instead of being tied should be pasted round the orifice with thin flower paste; but care must be taken that the paste does not extend beyond the end of the case, for this would prevent the fire from communicating with the composition, and the piece would consequently fail in the going off.