VARIOUS VINEYARD TOOLS.
General Notes.
—It is not my intention to here describe the various tools used in the vineyard so minutely that they can be made after the description, but simply to enumerate and call attention to them in order that as little repetition as necessary may be made. Every local blacksmith or mechanic invents, improves or patents vineyard tools of every description, and almost every year sees new tools introduced and older ones discarded. Still a few of these tools have become standard, and modifications of them are not always improvements.
The Sheep’s-foot.
—This is a very useful tool in planting grape cuttings. It consists of a round rod of three-eighths-inch iron and about three and one-half feet long, furnished with a cross handle at the upper end. The lower end is very slightly flattened out and split to a depth of one and one-half inches, the cleft thus formed being a little wider at the point of the bar, while the interior angle of the cleft should be rounded in order that the cutting may not be cut. The sheep’s-foot is used in very soft ground only, where it can be pushed down readily. In planting, the lower joint of the cutting is grasped by the cleft in the rod, and both are pushed down together to the required depth. A twist is then given the handle, so as to get the rod loose from the cutting. The rod is then pulled up, and a tamp with the foot sets the ground solid round the cutting. Care should be taken that the cutting is not pulled up with the rod, as it will prove fatal to the cutting.
The Planting Bar.
—This bar is used also in loose ground free from rocks. It consists of a flat bar of iron two and one-half inches wide, from three-eighths to one-half inch thick and three and one-half feet long, and is furnished at the upper end with a handle. In using this bar, it is first pushed in the ground, and a hole is made for the cutting. The cutting is then pushed down into the hole, the bar inserted alongside of it and pressed forward, in order to fill the hole and set the soil solid around the cutting.
The Dibble.
—This tool is simply a hard piece of oakwood, with a curved handle and pointed. It is a most useful instrument when the vines are being pruned. By means of it the soil is scraped off from around the trunk of the vine, to enable the pruner to cut off the suckers as close to the trunk as possible. Every pruner should be furnished with a dibble.
Planting Chains.
—These are best made of twisted wire, such as is used for clothes lines. Lines made of cotton or hemp are apt to stretch when dry, and shrink when wet. Copper wires are inserted to mark the distances at which the vines should be planted.
Spades.
—Spades are often used for planting. Long-handled spades are more useful than those with short handles.
Hoes.
—Besides the common, heavy hoes, very useful hoes can be made of old shovels which are too worn to be of account as such. New handles are set on the shovel blades at a right or sharp angle, thus transforming them into veritable hoes. With these tools much more work can be accomplished than with the common, manufactured hoe, which never cuts well. The large, flat-faced Italian hoe imported to this country from Italy is a most admirable instrument when planting cuttings in nursery rows. In fact it is then indispensable.
Plows.
—Of plows, heavy double plows for two horses are used for plowing in the center between the rows, and smaller plows for plowing closer to the vines. As these can be had everywhere, and as every grower has his own preferences, no description of them is required.
Cultivators.
—These are indispensable in the vineyard, and various models are in use. The common, diamond-shovel cultivator for both one and two horses is indispensable in every vineyard. The larger one of these may be greatly improved by affixing to the posterior shovels a cutter-bar, which should stand horizontal and on a level with the center of the posterior shovels.
Randel Disc Cultivators.
—These are useful in ground that has baked before the lately planted cuttings have begun to bud. They seldom cut or injure any of the cuttings, and the whole field may be gone over regardless of rows or cuttings.
The Ash Trough.
—The ash trough consists of a long trough on wheels, all made of galvanized iron, and furnished with numerous perforated holes. It is drawn by two or more horses through the vineyard, and the cuttings are burned in it as it goes along, and the ashes are scattered over the soil. As yet this trough is only used in a few of the largest vineyards, but when perfected will be useful everywhere, as by its aid the ashes may be saved for the vines instead of being wasted as is now so often the case.
Sulphuring Cans or Bellows.
—These are of various shapes and patterns. The cans have been superseded by the simple little burlap bag, which does the same or better work. The bellows are similar to common bellows, but are furnished with a distributing nozzle and with an air opening through which the sulphur can be poured.
The Cutter-sled.
—This is simply a sled four feet long by two and a half feet wide or more, under which has been fixed a horizontal bar of iron in the shape of a shallow U. It is used in the vineyard after the plowing and cultivation is finished, and when it is of importance to kill the few remaining weeds. The driver stands on the sled, which is pulled by one or two horses. It cuts all the weeds below the soil, and is a most effective and useful tool.
Vineyard Trucks.
—These useful trucks are California inventions, and of the greatest importance to the grower. They are now made of various sizes, but should never be over four feet wide, while three feet is even better, and their length should not exceed six feet. They are made to turn readily anywhere by having the front wheels or wheel movable, independently of the balance of the truck. By the aid of these trucks the grower can use horse labor in distributing his boxes and trays in the vineyard, even where the vines are planted so close that ordinary wagons cannot pass. The vineyard truck is now used in all Fresno vineyards, and is considered almost indispensable. The first truck ever made for this purpose was designed and invented by J. T. Goodman of Fresno.
Shears.
—These should be of the very best make of soft steel, and furnished with double springs. So far no good pruning shears are manufactured in this country, the best make coming from Switzerland, and retailed here at $3.00 per pair. It pays any grower to buy the best shears, as inferior ones not only last but a short time, but also do poor and slow work, and in the long run cost more than the best and most expensive make. With a good pair a pruner can in a day cut fifty per cent more than with a poor pair, and from ten to twenty-five per cent more than with an ordinary pair. It therefore can be readily seen how the extra price can be saved in the first day or two. Such fine shears should be handled and cared for very much like a razor. They should never be ground on a revolving stone, but only honed with oil on a fine hone. When the season is over they should be oiled, looked over and laid away. Large shears with wooden handles are not needed for Muscat vines. The best size shear is the medium size, which can be used with one hand.