PREPARATION OF STANDARD SOLUTIONS
!Approximate Strength, 0.1 N!
PROCEDURE.—Weigh out on the rough balances 13 grams of commercial iodine. Place it in a mortar with 18 grams of potassium iodide and triturate with small portions of water until all is dissolved. Dilute the solution to 1000 cc. and transfer to a liter bottle and mix thoroughly (Note 1).[1]
[Footnote 1: It will be found more economical to have a considerable quantity of the solution prepared by a laboratory attendant, and to have all unused solutions returned to the common stock.]
Weigh out 25 grams of sodium thiosulphate, dissolve it in water which has been previously boiled and cooled, and dilute to 1000 cc., also with boiled water. Transfer the solution to a liter bottle and mix thoroughly (Note 2).
[Note 1: Iodine solutions react with water to form hydriodic acid under the influence of the sunlight, and even at low room temperatures the iodine tends to volatilize from solution. They should, therefore, be protected from light and heat. Iodine solutions are not stable for long periods under the best of conditions. They cannot be used in burettes with rubber tips, since they attack the rubber.]
[Note 2: Sodium thiosulphate (Na_{2}S_{2}O_{3}.5H_{2}O) is rarely wholly pure as sold commercially, but may be purified by recrystallization. The carbon dioxide absorbed from the air by distilled water decomposes the salt, with the separation of sulphur. Boiled water which has been cooled out of contact with the air should be used in preparing solutions.]