Gilding in Oil.
In order to make good work in oil gilding there are several indispensable conditions which must be observed. First, a smooth ground. Second, gold size free from grit or skins. Third, in putting oil gold size on the work it must be dross black, ground in turpentine, and mixed with boiled linseed oil and a small piece of dryers; well sand-paper again, when this coat is dry. And now for the finishing coat of color, which should be flat, i. e., mixed with turpentine and a few drops of japanner’s gold-size, but no oil. The dross black should be first ground in turpentine and the gold-size added after. When this has dried, varnish with hard drying oak varnish, leave for a day or two, and then rub down with pumice-stone powder, sifted through muslin; use a piece of cloth or felt wrapped on a small block of wood, and first wet the surface to be rubbed with water; dry with a wash-leather, and re-varnish. The ornaments are usually done with stencil patterns, and the lines are done with straight edges and lining fitches. Stencil patterns can be cut out of card paper. Before using, give a coat or two of patent knotting. For gilding panels, give a coat of buff first, then a coat of gold-size, in oil. When this has dried just sticky, press the gold leaf upon it with a ball of wadding, and leave for five or six hours, then rub over with a piece of soft wadding, and wash well with a sponge and cold water. The gold will not need any preparation before painting on, but if varnished afterward use pale varnish. Screens should be painted in colors to match the rooms they are intended to be used in. Birds, flowers and animals are the subjects generally introduced for this purpose. Birds should be painted toward the top of the screen, animals, flowers, etc., in the centre or at the bottom.