Gloss Printing.
Gloss printing is done in two ways; one by using the gloss inks specially prepared for the purpose, the other by printing the gloss preparation on over the finished job, or over that portion of it required to be glossed. To the inexperienced this is a difficult operation, attended by many failures. It is accomplished as follows:—Prepare a tint block the exact size and shape to cover the printing to be glossed. The block should be of boxwood or hard metal—soft metal will not do. Fix it on the press and make it ready as for ordinary work, with a good, even impression. Wash up the ink table, the rollers and the block itself thoroughly, removing the least trace of ink. Replace the rollers and distributors. Now, with a clean palette knife put a little of the gloss preparation on the ink cylinder or table, let it distribute for about a minute, and then pull an impression; if it comes up perfectly clean, the work may proceed, but if there are any signs of dirt, it is best to wash up again at once. While working the gloss, keep the machine in motion, and should the gloss become too sticky (which it is apt to do) sprinkle a very little turpentine on the rollers. It is best to have a separate hand to put on the gloss, so as not to delay the feeder, and the sheets should be taken away at once and laid out singly to dry. The two most important points are to have the machine clean and keep it in motion. After printing, wash up the gloss quickly with benzine.