Canning Jars
Select standard canning jars made of tempered glass that can withstand high temperatures. The manufacturer’s name or symbol in glass will identify the product. With careful handling, jars last an average of about 10 years. Avoid using antique jars because there can be hair-line cracks not visible to the eye, causing jars to break.
Use canning jars in sizes suitable for the product canned and your family’s needs. Canning jars generally are sold in half-pint, pint and quart sizes with wide and narrow mouths. Large-mouth jars are convenient for packing such foods as whole tomatoes and peach halves. Quart jars are convenient for vegetables and fruits where your family has four or more members.
Examine the sealing edge of jars for nicks, cracks, or sharp edges that would prevent a seal. Discard any with these imperfections.
One-trip jars from purchased canned foods should not be used because they generally are not tempered to withstand the high heat required for home canning, and may break when subjected to the heat. Tops of these jars may not fit standard canning lids, thus preventing a good seal.
Home canning equipment.
Closures—jar lids and rings come with new canning jars. The sealing compound of lids recommended for one use only will not hold a seal effectively after the first use.
Select lids appropriate for the jars being used. You may find the two-piece units (flat lid with sealing composition and ring), one-piece lids, or flats with separate gaskets made of metal or plastic. Always follow the instructions for pretreatment as indicated on the box or container by the manufacturer. If no name is indicated on the lid, use a black wax marking pencil or crayon and mark the identity on each lid. If there are problems, contact the manufacturer whose name and address is on the box or container.
Screw ring bands may be reused if kept clean and dry in a protective container with a tight-fitting lid. Never use bands with rust, or pried up or bent edges.
If you have extra lids, store them protected in a dry, cool place.
One-piece zinc caps lined with white porcelain, with rubber rings, may be used. The caps may be reused if they have not cracked, spread or bent at the edges and are clean, like new. The rubber rings are effective only once because they tend to dry and deteriorate with age, often become porous, and sometimes crack.
If you have jars with bail wire clamps, sometimes called “lightning”-type jars, be sure they are not in the “antique” class. Lids for these jars are all glass, and rubber rings are used between the jar and lid for sealing. A wire clamp holds the lid in place during processing; after processing, the short spring wire of the clamp is snapped down to complete the seal.
A boiling water bath canner is needed for processing high-acid foods, such as fruits, tomatoes, tomato and fruit juice, and pickles.
Water bath canners in several sizes are available on the market. The container must be deep enough for a rack to hold the jars off the bottom of the canner. The depth allows water to be over the jars of food by at least 1 to 2 inches. Keep 1 to 2 inches of space above the water to allow for boiling; this prevents water from boiling over.
The canner must have a tight-fitting lid. Or you can use a large kettle with a tight-fitting lid, and a wooden or wire rack to hold jars off the bottom. There should be free circulation of water to every part of the surface of the jar and lid.
If you are going to buy a water bath canner, check the height, and the lid to be sure it is tight-fitting. The rack preferably should have dividers so jars will not touch each other or fall against the sides of the canner or each other during processing.
A steam pressure canner is absolutely essential in canning low-acid foods, such as vegetables, and insures the destruction of spoilage micro-organisms.
Ten pounds pressure is used for processing food in standard canning jars at sea level. This pressure corresponds to 240° F.
The steam pressure canner is made of heavy metal that withstands high pressure developed by steam. It consists of a kettle with a tight-fitting lid equipped with an accurate weight or dial gage to register the pounds of pressure in the canner. The lid must lock or seal to prevent escape of steam.
The canner must have a safety valve, petcock or steam vent that can be opened or closed to permit exhausting (venting), and a pressure gage. It must have a rack to hold jars at least ½ inch from the bottom of the canner.
A dial gage indicates pressure on a numbered instrument.
A weighted gage has no dial, but automatically limits pressure with weights preset for 5, 10, and 15 pounds pressure.
Scalding tomatoes in a blancher.
The pressure is adjusted for high altitude. For information on canning at altitudes above sea level, see the [later chapter] by Carole Davis.
To insure the canner’s proper working condition, check the dial gage for accuracy each year—or if a canner or lid has been roughly handled or dropped, the dial gage glass broken, or any parts are rusty. The manufacturer or your county Extension office can give information on testing availability. Study and follow the manufacturer’s directions for using your pressure canner.
Run through the process of operating the pressure canner on your range in a trial run before you get into the canning season, to be sure everything is working properly. Make a note of the dial setting of the range if you use an electric range for holding pressure steady.
Trying to use a pressure canner obtained from garage, rummage, or auction sales or handed down to you from someone’s attic may prove dangerous. You may not have any idea as to the care, handling, or storage of the canner. A manufacturer manual on care, use and replaceable parts usually is not available. Old-old canners did not have complete information—manufacturer’s name, address or model number—on the appliance.
General kitchen equipment is helpful in any needed washing, peeling, coring and slicing in the preparation of fruits and vegetables. Examples are, a vegetable brush for cleaning vegetables, a blancher or wire basket for scalding fruits and vegetables such as tomatoes and peaches to loosen skins for peeling, and a colander for washing delicate fruits such as berries.
A food mill is handy for making purees and straining fruits for making juices, and a strainer for straining juice. A long handled fork or plastic spatula aids in fitting and packing food and removing air bubbles. A wide-mouth funnel is very convenient for filling jars, and a jar lifter helps you avoid burns in handling hot jars. Use an automatic timer to time processing accurately.
The number of pints of preserved food you will get from a given quantity of fresh food depends on the quality, variety, and maturity of the fruit or vegetable; on the size of the pieces, and on the packing method used.
Selection of good sound fruits and vegetables is of paramount importance. The quality of canned fruits and vegetables will be no better than quality of the raw food used. For best flavor retention, preserve only those vegetables that are young, tender, and freshly gathered.