THE FIRST PILOT.

The first pilot was planned, 1832, by Robert L. Stevens. A frame made of oak, eight by four feet, pinned together at the corners, was made. Under one end of it a pair of wheels twenty-six inches in diameter were placed in boxes, and the other end was fastened to an extension of the axle outside of the forward driving wheels, it having been found by experience that a play of about one inch on each side on the pedestals of the front wheels of the pilot or engine was necessary in order to get around the curves then in the tracks. For years afterward there was very little change in constructing the pilots from that originally applied to the "John Bull."

The spiral spring, which held the front wheels of the pilot in place, acted substantially as the center pin of a truck. The turntables in use on the road were so short that it was necessary to unconnect and take off these pilots before turning the engine. After the pilot was adopted the forward large wheel on right of the engine was made loose on the shaft in order to afford additional play in going around curves. Other [⁶] changes and additions were also made in the locomotive.