—Go to a lumber yard or a planing mill and get one 2 × 2 scantling 12 feet long for the legs, and two 2 × 2 scantlings for the cross bars and the side bars; the middle cross bar can be any kind of a thick piece of wood. If you can’t get 2 × 2 scantlings get 2 × 4’s and have whichever size you get planed smooth on all sides.
At the same time get three boards 1 or 2 inches thick, 10 inches wide and 6 feet long for the top of the bench and two boards 1 inch thick, 10 inches wide and 4 feet long for the tool board. Saw the scantlings up so that you will have four pieces for the legs 2 feet 9 inches long; four cross-bars 2 feet 6 inches long, and two side bars 3 feet 6 inches long.
Build up the frame of the bench first as shown in [Fig. 5]; then nail, or better, screw a cross-bar to the middle of the 6 foot boards, lay them on top of the frame and nail or screw them to the end cross bars. When you have the bench thus far along put on the vise.
Fig. 6. a wood vise for your work bench
A wood-worker’s vise as shown at A and B in [Fig. 6] can be bought for $3.50 on up to about $9.00. The jaws are about 4 inches wide and 12 inches long and they open nearly 12 inches. All you have to do to fix it to your bench is to screw the rear jaw to the front left hand edge of the top of the bench as shown in [Fig. 5].
The tool board is not an absolute necessity but it is a great convenience. To make it saw off two boards 4 feet long, nail them together with a couple of strips of wood—these are called cleats—and round off one end as shown in [Fig. 5]. Screw the tool board to the back of the bench and you are all ready to make things in wood.
Fig. 7a. a carpenter’s tool chest