The first stage in wood-carving is to decorate a flat surface in very low relief by a process which, strictly speaking, is not carving at all. Let the beginner take a panel or thin flat board, let us say one of six inches in breadth, twelve in length, and half an inch or less in thickness. For this kind of work a finely grained, even, and light-coloured wood, such as holly or beech, is preferable. Draw the pattern on paper, of the size intended with a very black and soft lead or crayon pencil, place it with the face to the wood, and turning the edges over, gum them down to the edge of the panel. Then with some very smooth hard object, such as an agate or steel burnisher, an ivory paper-knife, or the end of a rounded and glossy penknife handle, carefully rub the back of the pattern. When this is done remove the paper, and the pattern will be found transferred to the wood. If imperfect, touch it up.
Fig. 20.
The pupil may now, with a pattern-wheel or tracer, indent or mark a line or narrow groove in the outline of the pattern. The tracer is the same implement of the same name which is used in repoussé or brass-sheet or metal-work. Its end is exactly like that of a screw-driver. To manage it properly hold it upright, and run it along, tapping it as it goes with a hammer of iron or wood, Fig. [20]. In some countries a stick of wood about six inches in length, and an inch broad at the butt, is used. Where the wheel cannot be employed, as in small corners, use the tracer. The pointed tracer, Fig. [21], used in leather-work, and in carpentry, is often indispensable for the smaller pattern-work.
Fig. 21. Pointed and edged Tracer.