in the matter and make the work look hard. If you do it, a blunted awl will serve your turn.
Fig. 60.
One had better mention everything, and therefore I will here say that,
of course, a large light must be made in sections; and these should not exceed four feet in height, and less is better. In fixing these in their place when the window is put up (an extra wide flat lead being used at the top and bottom of each section), they are made to overlap; and if you wish the whole drainage of the window to pass into the building, of course you will put your section thus—(fig. 61 A); while if you wish the work to be weather-tight you will place it thus—(fig. 61 B). It is just as well to make every question clear if one can, and therefore I mention this. Most people like their windows weather-tight, and, of course, will make the overlapping lead the top one; but it's a free country, and I don't pretend to dictate, content if I make the situation clear to you, leaving you to deal with it according to your own fancy. All is now done except the banding.
Fig. 61 a. Fig. 61 b.
How to Band a Leaded Light.—Banding means the putting on of the little ties of copper wire by which the window has to be held to the iron crossbars that keep it in its place. These ties are simply short lengths of copper wire, generally about four inches long, but varying, of course, with the size of the bar that you mean to use; and these are to be soldered vertically (fig. 62) on to the face of the light at any convenient places along the line where the bar will cross. In fixing the window, these wires are to be pulled tight round the bar and twisted up with pliers, and the twisted end knocked down flat and neat against the bar.
And this is the very last operation in the making of a stained-glass window. It now only remains to instruct you as to what relates to the fixing of it in its place.
How to Fix a Window in its Place.—There is, almost always, a groove in the stonework to receive the glass; and, except in the case of an unfinished building, this is, of course, occupied by some form of plain glazing. You must remove this by chipping out with a small mason's chisel the cement with which it is fixed in the groove, and common sense