Hull.—The Hull to be completed in every respect as a Revenue Cruiser of the 3rd Class, and all Materials found by the Contractor, except Copper Sheathing for the Bottom and Water-Closets, with all Shipwrights', Caulkers', Joiners', Blacksmiths', Copper-smiths', Braziers', Glaziers', Plumbers' and Painters' work.
Cathead.—To have an Iron Cathead with two Shieves strong enough to cat the Anchor, and fitted both sides.
Cock.—To have a Stop Cock fitted forward under the Lower Deck, to let in Water occasionally.
Water-closet.—To have a Patent Water-Closet of Danton's fitted below, and a Round-house on Deck, aft Starboard side complete, with a Pantry for meat, the Larboard side to correspond with the Round-house, and a Poop Deck between both, nailed with Copper Nails; also a seat of ease on the Larboard side forward for the Crew, with Lead Pipe to water edge; the whole of the Locks throughout to be Brass and Brass Works.
Air Openings.—An inch opening to be left all fore and aft under the Clamp both sides, also in the Ceiling between the Lower Deck Beams, and another in the upper part of the Bins, and one inch auger hole bored between the Timbers in the run aft and forward where lists cannot be left out, also a hole of one inch in all the Timbers, fore and aft, to admit air, and those holes seared with a hot iron; all Chocks for securing the frame Timbers together are to be split out before the bottom Plank is worked.
The Cutter to remain in frame for one Month before closed in, then when the outside Plank is worked and all the Sap taken off the Timbers, and before the Ceiling is worked, to give the Timbers a good coat of Stockholm Tar.
Should there be any omission or want of more full statement in this Specification, the Contractor is to understand that the Hull of the said Vessel is to be fitted and completed fit for Sea in every respect as is usual for a Revenue Vessel of her Class, the Board finding the Copper Sheathing and Water-Closet.
Defects to be Amended.—Any defects discovered in the Timbers or Plank, &c., by the Officer or Overseer appointed by the Honourable Board of Customs to survey and inspect the same, or insufficient workmanship performed to the said Cutter during her building, the said defect or deficiency both in the one and in the other, shall upon notice thereof to the Contractor be forthwith amended, and the said Overseer shall not at any time have any molestation or obstruction therein.
Note.—For a 150-ton Revenue Cutter the following dimensions were employed:—
Length.—(Stem to Sternpost) 72 feet. Keel for Tonnage, 68 feet.
Breadth.—(Extreme) 22 feet 10 inches.
Depth.—10 feet 3 inches.
Beams to be 7 inches.
Deck to be 2 inches thick.
Four Oak Legs to be supplied