Fig. 77. The waist pattern pinned to the material
Fig. 78. Notches of sleeve put together
Let us make the sleeve first. Take one sleeve and holding with the right side join notches together ([Figure 78]). Baste the sleeves up on the seams one eighth of an inch from the edge. When the basting is finished make a row of fine running stitches. Turn the sleeves on the wrong side and baste them before working the combination stitches. The sleeves are now ready to be banded. The band is taken and sewed on the short side. The seaming is taken on the wrong side of the material. A little seam is taken on each of the long sides of the cuff. Fold the cuff in half. The turns or folds are opened out and now turn the cuff inside out. Run a gathering thread at the lower edge of the main part of the sleeves starting the thread one half inch from each side of the seam. Place the cuff around the sleeve so that cuff seam rests on the seam of the sleeve. Pin into position. It will probably be necessary to pull or adjust the gathering thread so that the lower part of the sleeve be just the size of the cuff. Baste the band on after it has been pinned satisfactorily before working the combination stitch.
Turn the sleeve inside out and fold the cuff in the creases. Hem the inner side of the cuff to the wrong side of the sleeve. On the upper side of the sleeves run another gathering thread about one inch and a half from the seam ([Figure 79]). We have now finished with the sleeve until the waist proper is ready.
Fig. 79. Gathering the top of the sleeve
Now take the centre back and side back and baste them together. Join the pieces so that the notches correspond. Work the combination stitch three eighths of an inch from the edge. The side fronts are joined to the backs under the arm and on the shoulders. The front is then sewed to the right side of the waist only. It will be necessary to face the centre front piece and the left side front. Take a bias strip of material not more than three quarters of an inch wide and fold an eighth of an inch on each side of this strip. Join the shoulder seams together, one side of the back to the right side of the front and the other side to back. Sew with combination stitches, then make a felled seam as explained for the sleeve. Baste the turned fold to the right-hand side of the waist by opening out creased side and placing the two right sides together and stitching one eighth of an inch from the edge. Turn the bias over to the wrong side of the waist and slip stitch. Slip stitching, as I have explained before, is somewhat like hemming; only the stitches are taken back of the folded edge and catch one thread only of the material.