The other bias band is basted in like manner to the left-hand side of the waist.
Fig. 80. The gathers on the upper part of the sleeve
The sleeves are ready to be put in. Measure one and one quarter inches from the under arm seam on the waist, which is the short seam near the front of the waist. Pin the seam of the sleeve to this point. Pin the rest of the sleeve so that the gathers are evenly distributed. Pin the right side of the sleeve to the right side of the waist. Baste securely. Remember that the gathers should be thickest on the upper part of the sleeve ([Figure 80]). Stitch with fine back-stitching and then overcast. The neck may be bound or may have the collar attached.
Turn and hem the outer edge of the collar; a ruffle of lace may be added if desired. Baste the collar to the waist, and try the waist on Sally Ann. If it is a satisfactory fit, stitch in place. It is well to cover the raw edges with a little bias fold. Hem the fold down on both sides.
The long strip is not joined, but a half-inch hem folded on one side and then stitched. The skirt is plaited or kilted, as it is often called. A hem is made on each of the short sides of the strips. Now crease the material as if you were going to make a tuck three quarters of an inch deep. A box plait will next have to be planned; again crease your material as if you were going to make a tuck three quarters of an inch deep. These creases must be exactly three quarters of an inch from the double fold of each piece. Measure an inch and a half, then turn the material under so that a three-quarter inch piece is under the left side of the waist line. This completes the box plait.
The plaits from there on are folded toward the left, while the first two were toward the right. Baste each plait down securely. When working on cotton materials that have a lot of dressing, the creases are likely to stay in without basting, but while working on it the edges are apt to get turned up. Basting ([Figure 81]) is therefore the surer and safer way to keep the plaits in position, while for woollen or soft, sleazy materials it is the only way.
When every plait has been basted lengthwise, take another thread and baste them crosswise three or four times.