Crown tips—
The top of the crown may be kept soft-looking or it may be made of buckram, producing a stiff effect. Both methods will be given.
Soft crown tip—First shape side crown to fit headsize wire on brim, which will be an ellipse. Cut piece of crinoline, the exact shape of the crown, plus one inch all around. Pin this over top, puffing it a very little, and sew with stab stitch close under wire. Cut surplus material off to one-fourth inch.
Stiff crown tip, made of buckram—Lay top of side crown on smooth side of buckram and mark the shape with a pencil. Cut buckram one-half inch outside of this mark. Next, in order to fold down this stiff crown tip, it will be necessary to cut, from this half-inch of buckram outside the pencil line, small wedge-like pieces, about one inch apart. Cut them close to the line drawn. Pin this piece on top of crown, press flaps down and sew on with stab stitch.
Crowns—
If a round crown is to be used it is advisable to buy a ten-cent separate crown or a frame with a round crown. If an entire frame is purchased, remove the crown and wire its bottom edge. After some skill has been acquired by the student of millinery, a round crown of fabric may be blocked by hand over a wire crown.
To cover round crown—
Pin material on top of crown with bias at front. Pull with the straight of the material and pin just below edge of curve. Sew one-half inch below this with stab stitch, trim material off close under this stitching. Remove pins. Fit a bias piece of material, using same method and measurements as for side crown of velvet sailor in chapter II. Sew the crown to brim before adjusting the side crown covering. Pull this bias piece over crown and pin smoothly in place. Finish top and bottom of this band by turning the edges over a wire. Use same stitch as in finishing edge of facing on brim.[13-1] This makes a neat finish for a hat which will demand little trimming. If the amateur finds it too difficult to finish the bottom of a side crown in this way, the edge may be covered with a fold of material or a narrow ribbon; the top may also be finished by a narrow ribbon, but finishing neatly with a wire should be mastered if possible, as this style of finish is used in many places.
[7-1] To cut wire see [chapter IV].
[7-2] To tie wire see [chapter IV].