[13-1] See [chapter II].
CHAPTER II
COVERING FRAME WITH VELVET
Material required one and one-half yards milliner's velvet or any velvet eighteen to twenty-four inches wide. If velvet used is thirty-six inches wide, one yard will be sufficient.
To cover brim—
Place corner of velvet at front of brim on top side (smooth side). Edgewire and headsize wire should always be on top of brim. Turn velvet over edge of brim and pin. Stick pins through at right angles to brim to avoid marring the velvet. Pin closely all around edge of brim, pulling material with the thread to remove any fullness. Do not pull tight enough to bend the brim. Trim velvet off one-fourth inch to turn under brim. Baste close to headsize wire on top with stab stitch. Cut velvet out inside of headsize wire, leaving a half inch to slash and turn up with the buckram.
To sew velvet edge to brim—
This should be done with a close overcasting stitch on the under side, being careful not to prick through to the right side of the velvet. It is sometimes advisable in preparing the frame to stitch the buckram in from the edge about one-fourth inch with the sewing machine, using a long stitch. This stitching may then be used to put the needle through when sewing the velvet down. If the velvet seems thick and heavy-looking on under side after sewing, it may be pressed down with a hot iron. If done quickly and lightly, it will not show on the right side.