Make your own hats

by Gene Allen Martin

CHAPTER VII

TRIMMINGS

Milliner's fold—

Cut from a piece of velvet, satin, or any fabric which is to be used, a bias strip one and one-half inches wide and of the desired length. This must be on a true bias, which is found by placing the warp and woof threads parallel. Any other bias is called a garment bias. Hold the wrong side toward you and turn the bottom edge up on the wrong side toward you and up to the center and baste close to the edge. The basting thread must be loose enough to permit the fold to be stretched. Leave the basting in. Next fold the other raw edge down until the two edges meet, but do not baste. Fold again, keeping this last fold one-quarter of an inch or a little less from the other folded edge. Hold in place and slipstitch down. Slip the needle through the edge of the fold and take a long stitch, then, going down through to the other side, take a short stitch. Come back through a little under the fold to hide the stitch. Slip the needle along the edge of the fold as before, and continue in this manner. The thread should be kept loose all the way to permit the fold to be stretched slightly when used. The fold when finished should not twist or look as if it had a stitch in it.

Another separate single fold may be added to this; it is then called a French fold. The milliner's fold has many uses, such as finishing the edge of hats, and the bottom of crowns, to cover the joining of the hat to the brim. It is used sometimes around the top of a square crown and is much used in mourning millinery, when it is made of crêpe.

Bows

For the inexperienced in bow-making there is no better plan than to copy many different styles of bows, using either tissue paper or cheap cambric, as ribbons are ruined by being made over too many times. Bow-making is sometimes quite difficult for an amateur, while for some students of millinery it is very easy, but any one with patience may become quite expert in time.

Cut the tissue paper or cambric the exact width of the ribbon which is to be used. In this way the exact amount of ribbon may be determined, as well as the length of each loop. If a stiff, smart-looking bow is to be made, fold the ribbon in loops before pleating. If a soft-looking or puffy, “fat”-looking bow is desired, pleat the ribbon singly before making the loops. The soft bow is often used for children's hats. After the desired number of loops is made, wind a strong thread around the center and over this wrap the remaining end of ribbon around the center several times until the center is filled up sufficiently to look well.

Bows of maline—

Maline is one of the most beautiful materials used in millinery and it lends itself to many uses. Hat frames are covered with maline; it is used to cover wings to keep feathers in place; to cover faded or worn-out flowers; for shirred brims and crowns; for pleatings; for folds on edges of brims to give a soft look; and for bows.