A bow of maline requires wiring with a very small tie wire or lace wire. The wire may be caught in a fold at the edge of the loops, or the loops may be made double with the wire caught inside.
Ribbon is sometimes wired if a stiff effect is desired. Silk, satin, velvet, or any kind of ribbon can be used. The flat ribbon wire is sometimes pasted between two ribbons with milliner's glue. Often two colors are rather effectively used in this way. The wire may also be stitched to one edge of the ribbon. This is done by turning the ribbon over the wire at the edge and stitching on the sewing machine. The ends of the wire should extend two inches beyond the ends of the loop of the bow. After the bow is arranged, these ends should be bent out and back, making loops which are sewed down to the hat. This holds the bow very firmly, especially if a small piece of buckram is placed inside the hat at the point at which the bow is to be sewed. This re-enforces the frame and makes it still more firm. If a bow is to be placed on top of a crown, a hole may be made and the ribbon which completes the middle of the bow may be brought up from the inside of the crown through this opening, over the bow, and down through this opening and fastened inside of the crown.
A narrow ribbon of velvet is very pretty twisted over a wire and two perky loops and ends made. These are very pretty perched on the edge of a brim or among flowers on the hat.
True lovers' knot—
This is not, strictly speaking, a bow, but comes under this head. The ribbon used is made into the knot and sewed flat as it is made. It may be sewed on the brim or side crown and is very effective made of gold ribbon.
Tailored bow—
This bow is usually made from a piece of ribbon which has both sides alike, although it may be made from any ribbon. A Knox tailored bow is made from gros-grained ribbon. Cut a small piece of buckram for a foundation to sew the ribbon on. This should be sufficiently small so that the ribbon will conceal it. Make two loops of equal length, letting the ribbon lie perfectly flat. Measurements should be very exact. Sew these loops firmly to the buckram; fold the ribbon back and forth to make these loops without cutting. Next fold two more loops, one on each side, one-quarter of an inch shorter and exactly on top. Sew firmly and cut the ribbon off at the center. Fasten two short ends to the back of the bow, allowing them to extend one-quarter of an inch and cut diagonally. Take a short length of ribbon and pleat it once through the center. Wrap this once around the bow and fasten at the back.
This bow is much used on sailors or any tailored hat. There are many kinds of fancy bows brought out from season to season, but if the making of a few styles of standard bows is mastered, others may be easily copied.
SECTION OF MALINE POMPON SHOWING METHOD OF FASTENING ONTHE WIRE |
RADIATING PLEATING MADE ON LOW PYRAMID OF BUCKRAM |
TRUE LOVERS' KNOT | |
RADIATING PLEATING MADE ON BUCKRAM FOUNDATION | |
SECOND METHOD OF MAKING AN ORCHID CENTER (see [page 91]) | |
