HIVE-STANDS, OR PEDESTALS.
Hives standing singly, in the open air, must be so placed as that there is no risk of their being overthrown by the wind or other casualty, and various kinds of supports have been devised. Whatever is preferred, it ought to afford facilities for allowing the lifting up of the hive on its board at pleasure. A single pedestal or post is sometimes used, cut flat at the top to six or seven inches square. It may stand out of the ground fifteen or sixteen inches, and be firmly fixed, to avoid shaking, which alarms the bees. Sometimes a higher elevation than this is given, but it is not expedient to subject the hives unnecessarily to the action of the wind, any more than it is to place them so near the ground as to cause the bees to be affected by damp exhalations. On the under side of the centre of the hive-board fix four bars of wood (or three will do), of about two inches square, so as to form a cap or socket, fitting over the top of the pedestal. The board may be there secured by the insertion, diagonally, of one or two pins, through the sides of the cap and into the post. This plan may be varied by means of the two pieces or arms, let edgewise flush into the top of a post, crossing it diagonally: on this the hive-board may rest, or be secured by a button or two.
Or, on the top of a pedestal, four or five inches in diameter, a piece of board, of about nine inches square, may be fixed as a table. Upon this place the hive-board, of which the cross bars, appended to its underneath side, are so adjusted in point of distance apart, as to come on each side of the table, being there secured by a pin or turn-button.
This last-described stand may be improved, at a little further cost. Nail upon the pedestal a piece of strong board, eight or nine inches wide, and three inches longer than the outside width of the hive-board. Underneath the table thus formed, a couple of struts or angle-pieces must be fixed, to render the whole firm. The under-side bars of the hive-board are adjusted to fall on each side the table, as before detailed. The extra three inches of the latter must be thrown to the front, where it is designed to form a projecting alighting platform for the bees. This part is occupied by a piece of wood nailed to it, and chamfered to meet the hive-board, to which it forms a stay.
Another support to an out-door hive is made by means of four props, driven upright into the ground, and cut off level, at about sixteen inches high. The hive-board must have two cross bars screwed to its under side, from front to back, just coming within the uprights: to make it still more steady, four small blocks can be appended near the corners, between the cross bars and the edge of the board, to hold the latter in the opposite direction, as seen by the dotted lines in our illustration.
The same remark applies to the hive-stands just described as was made in the last section, viz., they can be adapted equally well to round as to square hive-boards. It may be well also to observe that, instead of sinking a pedestal into the earth, where decay soon ensues, it can be fixed upon strong cross pieces or feet, these being fastened to the ground by pins passing downwards through them.
