Place point of dividers at M, and with N as a radius add an inch and strike to cross line NI, locating NX on line NI; measure from N to O and lay out this distance, with an inch added, by placing dividers at NX and crossing line OI, locating point OX; locate PX, QX, RX, and so on, in the same way, and rule from NX to TX, striking each intersection on the way, and also from each intersection to W, as dotted lines. When all located the lines between 5—6—11 and 12 will be the outline of the tail, those between 3—4—9 and 10 one of the pipes, and 1—2—7 and 8 the other pipe.
Now, lay the patterns over a soft board, and with a nail perforate the outline of the arch from A to T, the outline of the drapery from G to H, I to J and K to L, and also the outlining points of the pipes and tail, namely, 1—2—7 and 8, 3—4—9 and 10, 5—6—11 and 12, and the points NX, OX, PX, QX, RX and SX.
(Continued on page 51.)
Fig 107B
Fig 108
Fig 109
