Plate 25.
Next cut the four top pieces to size, two being 3/8" × 3/4" × 6" and two 3/8" × 3/4" × 7". These are also rounded on both ends. Holes are bored 3/8" from each end of all of these and also half way between their ends, as shown in [Plate 25].
These pieces should be carefully sanded with No. 1 sandpaper.
The cross pieces are cut from 1/4" dowels as follows: Four pieces, 8-3/4" long; six pieces, 8" long; and one piece, 7-1/4" long.
The long dowel sticks are the ones that go at points a, b, c and d, Plate 25, on the outside legs. The 8" dowels go at points e, f, g, h, i, and j. The single short dowel goes at point k.
Examine the drawing carefully and see that the four top pieces are placed on the correct dowels. Hold all dowels, which are not at movable points, with 3/4" brads.
Be sure every piece is in its proper position before driving in the brads and then be positive that no brad is being driven at a point where the dowel must be free to move in the hole. It is always best to assemble the rack completely and by closing and opening it learn clearly just where the brads are to be placed.