No further finish is necessary.
[CHILD'S WASH BENCH.]
This bench may be made in various sizes to fit different heights of children. The top consists of three slats and for the size bench shown in [Plate 26], the slats are made 3/8" × 1-3/4" × 18". These slats have screw holes bored 2-3/8" from the ends and 3/8" from the edges, as shown. These are countersunk to receive 1" No. 6 flat-head screws.
Two braces are made 3/4" × 1/4" × 8". These are to support the slats. One inch from one end of these braces, and 5/8" from the edges, a hole is bored with a 3/8" bit. The same distance from the other end a similar hole is bored and a piece is sawed out, as shown in the drawing, to receive and support the dowel rod.
The legs of the bench are cut 3/8" × 1" × 12-3/4". One-half inch from one end a hole is bored with a 3/8" bit. One and one-half inches from the other end a similar hole is bored and 7" from the same end the third hole is bored, making three in each leg. Care must be taken in boring these holes not to split the work as the bit goes through. Bore through on one side until the spur of the bit just starts through on the opposite side. Remove the bit and place the spur point in the small hole made by the spur and bore back in the opposite direction.
Plate 26.