Fig. 67.—Hand spear for killing
seals from kaiak; Koksoak.
Fig. 68.—Togglehead for hand spear.
I have already described the large harpoon used for striking white whales and large seals from the kaiak. A short-head spear (Fig 67, No. 90164) is used for dispatching wounded seals or white whales, or for killing white whales when they have been driven into a shallow arm of the sea when the tide ebbs and leaves them partly uncovered. It has a short wooden shaft with a ferrule of ivory, holding a short ivory loose shaft, kept in place by thongs, on which is mounted a toggle head like that used on the big harpoon. The line is either attached to the kaiak or to a small float made of the inflated intestine or skin of a seal. The toggle heads for these spears are made of ivory, and fitted with iron blades (Fig. 68). I have already referred to the large sealskin float in describing the kaiak.
Fig. 69.—Sealskin float.
Fig. 69 (No. 3531) is such a large sealskin float or á va tuk. The skin is removed from the body by skinning around the gums and carefully taking out all the flesh and bones through this orifice. As the operation proceeds the skin is turned back and at the completion of the work is inside out. The flesh side, now the exterior, is carefully scraped to free it from all fleshy matter. The hind flippers are cut off at the ankle and the skin either sewed or stoutly wrapped with thong. The fore flippers are usually left attached to the skin after the flesh has been scraped from them. The skin is now inflated with air and hung up to dry. In a few hours it is turned with the hairy side out and again inflated for awhile. The mouth and all other openings in the skin are carefully sewed up. A large button of ivory, shaped much like a pulley, nearly 2 inches in diameter, is put where the mouth of the skin is and a portion of the skin carefully wrapped around it, thongs of sealskin tightening the moist skin in the groove of the mouthpiece. This piece has a hole about one-third of an inch in diameter bored through it. The hind flippers and tail have a stick of 2 or 3 inches in length placed within the skin and are then firmly bound around the stick, which serves to stop up any hole and also to furnish a handle by which to drag or hold the float. The hole in the mouth-piece is plugged with a stopper of wood. When the float is wanted for use the skin is inflated. When inflated the float has a diameter about two-thirds the length. If it is to be attached to a tracking line the float is fastened by the stick, which is secured within the skin of the hind flippers and dragged backwards. The function of the float in this instance is to prevent the tracking line from becoming “fouled” among the rocks and stones of the beach along which the line runs in towing a boat (or umiak). In a similar manner it is affixed to the harpoon line used for large marine mammals, such as the white whale and the larger species of seals. This float not only retards the flight of the speared animal, but it serves to mark the spot where it sinks, for at certain seasons the seals sink as soon as they die. A speared animal always sinks more quickly than one shot dead with a ball, probably because its struggles are more prolonged in the first instance and exhaustion of breath is more complete.
The hair of the animal whose skin is intended for a float is sometimes scraped off before the skin is removed from the body, otherwise it may be left until the skin is partly dry and then be shaved off. The manner of loosening the hair is similar to that used by butchers of hogs, only that the boiling water is poured on and a small patch of hair pulled off at a time, instead of submerging the entire animal. The hair from the green skin must be carefully pulled out or else the black scurf adhering will be detached and thus render the skin less nearly waterproof.