CHAPTER XVI.
TRANSFERRING BEES.
AS some of my readers may have bees in ordinary hives, which they would like to transfer to the Controllable Hive, I will devote a chapter to Transferring.
If you have bees in a box or patent hive, or any of the thousand and one bee hive humbugs, which are of little or no profit, and cause you much trouble and perplexity in swarming time, and frequent and heavy losses in winter, you can move them into Controllable Hives—comb, honey and bees together—and manage them on the plan here recommended, and they will winter well, come out strong and healthy in the spring, and cause comparatively no trouble in swarming time, yielding you a good profit yearly.
The best time to transfer is as early in spring as the weather becomes warm enough to keep the bees active every day, which in the New England States is usually in April. It is a good time to transfer about twenty-four days after the first swarm issues from a stock as at that time there is but little brood, and usually but few bees. October is a very good time to transfer, but not as good as either of the times before mentioned. Great care is required to prevent robbing, and also to have the comb frames all filled with combs, and in good position for the bees to winter. As cold weather is so close at hand, the bees will have but little time to arrange for winter.
For transferring, construct the Controllable Hive as directed, with exception of the comb frames. Make several holes one-fourth inch in diameter through the top, bottom and ends of frames, and a like number of sharp wooden pins about two inches long to fit these holes.
Early in the morning before the bees begin to fly, prepare your smoker, go to the hive you propose to transfer, and before you touch it, smoke the bees at the entrances moderately, giving them two or three puffs, waiting about a minute and giving them two or three more. Then stop the entrances, so no bees can escape. Take the hive from the stand and carry it to some out-building, so the bees from the other hives will not trouble you, and get a taste of the honey thereby inciting them to robbery. Turn the hive bottom up, and with two sticks each about a half-inch in diameter and twelve inches long, strike the hive lightly half a dozen times, and then wait for two or three minutes. Then with the sticks on each side of the hive, drum briskly (but lightly so as not to break the comb,) for about five minutes. Then puff smoke under the bottom board on all sides. Much of this preliminary work is for the purpose of confusing the bees, and inducing them to fill themselves with honey from the cells of the hive, as a bee gorged with honey will never volunteer an attack for the purpose of stinging. The bees are now ready to be transferred. You will need some one to assist you, and it will be necessary for you to put on your articles of protection, and keep your smoker in readiness for use, as occasionally a swarm is hard to subdue, though the great majority of them are perfectly docile after the treatment recommended. But we are to "beard the lion in his den," and to be forewarned is to be forearmed.
The bees usually manifest their submission by a loud humming noise. If after you commence operations (before you get the side of the hive off) they show a disposition to be cross, replace the bottom board, close the entrances, if open, and give the insects a good smoking, at the entrances, and by raising the bottom board enough to introduce the smoke; give them the smoke freely for several minutes. Then again remove the bottom board. (These directions apply to the common box hive. If hives of a different pattern are operated upon, vary the operation to conform to the requirements of the case, applying the same principles.) Then with a chisel and hammer remove one side of the hive (the side to which the bees have attached the least comb,) and with a thin, sharp table-knife, cut the edges of the comb from the sides of the hive. It is well to have a table or stand near by, with a cloth folded in several thicknesses, on which to lay the sheets of comb with the bees adhering, if necessary. The cloth prevents crushing. Cut out a comb from the hive with the bees adhering, and cut off the edges, if required, so it will fit the new frame closely at the top and bottom. No matter if it does not go the whole length of the frame from front to rear, as the bees will finish it.[11] Have the comb occupy the same position, relatively, in the new hive, that it did in the old. When the comb is in place in the frame, secure it by putting the wooden pins through the holes in the frames into the combs, and having fastened it firmly in place by means of the pins, place it in the Controllable Hive in its proper position.
[11] But very few hives are large enough for their combs to fill the moveable comb frames of the Controllable Hive.