Figure 14
Figure 15
The "canoe awl" of the fur trade was a steel awl with a blade triangular or square in cross-section, and was sometimes made of an old triangular file of small size. Its blade was locked into a hardwood handle, and it was a modern version of the old bone awl of the bark canoe builders, hence its name.
The plane was also used by modern Indians, but not in white man's fashion, in which the wood is held in a vise and smoothed by sliding the tool forward over the work. The Indian usually fixed the plane upside down on a bench or timber and slid the work over the sole, much as would be done with a power-driven joiner. However, the plane was not very popular among any of the canoe-building Indians.
Figure 16
The boring tool most favored by the Indians was the common steel gimlet; if a larger boring tool was desired, an auger of the required diameter was bought and fitted with a removable cross-handle rather than a brace.
One steel tool having much popularity among canoe-building Indians was the pioneer's splitting tool known as the "froe." This was a heavy steel blade, fifteen to twenty inches long, about two inches wide, and nearly a quarter inch thick along its back. One end of the blade ended in a tight loop into which a heavy hardwood handle, about a foot long, was set at right angles to the back edge of the blade, so that, when held in the hand, the blade was cutting edge down, with the handle upright. The froe was driven into the end of a balk of timber to be split by blows from a wooden maul on the back of its blade. Once the split was started, the maul was dropped and the hand that had held it was placed at the end of the blade away from the handle. By twisting the blade with the two hands the split could be forced open. The froe was a most powerful and efficient splitting tool when narrow, short plank, or battens, were required. The balk to be split was usually placed more or less end-up, as its length permitted, in the crotch of a felled tree, so as to hold it steady during the splitting. The pioneer used this tool to make clapboards and riven shingles; the Indian canoe builder found it handy for all splitting.
