(7) Work old wire and loom out of timer head hole and free from vehicle.
(8) On earlier models, the coil to timer wire was soldered to end of insulated stud. Removal of stud is necessary to remove this wire, or replace it with a shielded wire. Note location of stud insulations on inside and outside of timer head, for correct installation when reassembling.
c. Install.
(1) Pass end of wire, shield terminal, and loom up through hole in timer base.
(2) Ground the wire shield terminal under head of timer base mounting screw ([fig. 52]).
(3) Connect wire end terminal to insulated stud so that wire leads away from stud in direction shown ([fig. 52]).
(4) Pass coil to timer wire up alongside and to rear of frame saddle post tube to reach rear of spark coil.
(5) Ground the wire shield terminal to coil rear ground connection ([fig. 53]).
(6) Connect wire terminal to coil rear primary connection ([fig. 53]).