(1) Remove front wheel (par. [125]). After front wheel is removed, brake side cover and shoe assembly is accessible for shoe replacement.
(2) Remove brake shoes. Brake shoes and springs can be pried off pivot stud and freed from operating cam without removing springs.
f. Install Brake Shoes. Observe that brake shoes are made for upper and lower positions and are not interchangeable. Recess in end of shoe for pivot stud head determines position of shoe in assembly.
(1) Engage ends of springs in shoe holes from the inside before installing shoes in brake side plate.
(2) With shoes and springs assembled, install the shoes so that ends of shoes will slip over pivot stud and shaft operating cam.
(3) Install front wheel and brake assembly (par. [125]).
(4) Loosen nut on brake shoe adjustable pivot stud and while applying pressure on brake hand lever, retighten pivot stud nut. This is to center brake shoes within the brake drum.
(5) After new or relined shoes have been installed, check brake hand lever and, if necessary, adjust the control wire (step d above).