Motorcycle, Solo (Harley-Davidson Model WLA)

by United States. War Department

E—ROLLER.

F—ROLLER BLOCK.

G—PLUNGER.

H—CONTROL WIRE.

I—WIRE RETAINING NUT.

RA PD 310263
Figure 67—Handle Bar Grip and Wire Control, Disassembled

c. Install Throttle Control Wire ([fig. 67]).

(1) Pass hollow screw over control wire with threaded end of hollow screw facing button on end of wire. Install screw in end of plunger. Securely tighten screw.

(2) Apply grease or engine oil to control wire and insert end into control wire housing.

(3) Apply grease to plunger and push plunger and wire into handle bar until plunger pin hole is exposed in handle bar slot. Work plunger or turn it within handle bar so that pin hole and flat side are upward and are centered in slot; then insert roller pin into plunger hole, roller block (with flat sides), and roller in order named. Apply grease to plunger pin and roller and to outside of handle bar end.