A paper might be written on the different methods and numerous plans invented and suggested for the transportation of the Needle. Sir James Alexander had made the acquaintance of Mr. John Dixon, a civil engineer, and he, too, was interested in the monolith. Professor Erasmus Wilson and Mr. Dixon were introduced and discussed the subject together, with the result that Mr. Dixon undertook the responsibility of the conveyance of the column to England, Professor Wilson arranging to pay the £10,000 on its erection in London. A construction was therefore carefully designed in England for encasing the Needle, so that it would be a sea craft of itself, and this was sent out to Egypt in pieces.
From a] [Photo.
THE TUGS IN ACTION.
One of the principal considerations when making their designs was that the Needle when encased required to be launched by being rolled into the water, instead of being sent off in the usual way. Another of the chief difficulties to contend with in the removal of the obelisk was that the bay near which it was lying was unsafe for ships to anchor in, as it was exposed to severe gales and the ground was covered with shoals. The Needle was raised some feet above the ground, the smaller end swung round to be parallel with the sea, and when in this position the work of encasing it was done.
When in this act of turning it, the ground appeared to be giving way under it, and, on examination being made, it was found to be resting on a small vault, which was 6ft. long by 3ft. wide and 4ft. high. It was evidently an ancient tomb, for two human skeletons and some small jars were found in the cavity. The skulls were preserved and put on board the pontoon, when ready for sea, but after the storm in the bay they were never seen again, and the sailors, being foreign, are supposed to have thrown them overboard, through superstition.
The Needle whilst raised and ready for encasing had the plates riveted in place round it, the inside was packed with elastic timber cushions to preserve the stone when being rolled into the water, or in case of any deflection in the vessel's length, which might occur through the waves. The casing was made water-tight, and the greatest care had to be taken to have the column quite in the centre of the cylinder, where it was fastened in position.
From a] [Photo.
AT THE BRINK.
For the purpose of getting it into the water, large wooden wheels, 16-1/2ft. in diameter, were put on either end, and planks were laid for it to roll down. From heavy lighters lying in the bay, wire ropes were taken and wrapped many times round the cylinder. Also from the land side ropes were secured to it, in case, when set in motion, it went off at too great a speed, and thus the ropes could check that fault. On August 28th, 1877, all was ready for the launch. Unfortunately, the morning commenced with a thick fog, which only cleared away as the day wore on.